Trudell Medical International AeroEclipse XL User manual

Using An AeroEclipse® XL Reusable
Nebulizer
Many medications are available as inhaled treatments. Inhaled
methods deliver medication directlyto the airway, which is
particularly useful for respiratory problems. The patient and health
care provider can choose from a variety of delivery systems for
inhaling medication.
A nebulizer delivery system consists of a nebulizer (small plastic
medication cup with a lid that drops into the cup and twists) and a
source for compressed air. The air flow from
the compressor to the nebulizer changes the
medication solution to a mist. When inhaled
correctly, the medication hasa better chance
to reach the small airways. This increases
the medication's effectiveness.
Assembling the AeroEclipse®Nebulizer and Air Compressor
1. Place the compressor and nebulizer on a clean, flat, hard
surface. The compressor should be placed where it can safely
reach its power source and where you can reach the ON/OFF
switch.
2.
Connect the air tubing from the compressor to the nebulizer
base.
Preparing the Medication
1. Wash your hands prior to preparing each treatment.
2.
Always use a clean nebulizer.
3.
Untwist and remove the medication cup from the nebulizer unit.
4.
Measure the correct dose of medication and other solutions
prescribed by your health care provider.
5.
Put the medication and other solutions into the medication cup.
6.
Replace the top of the nebulizer. Gently twist the top to tighten.
7.
Ensure the nebulizer is kept in an upright position so your
medicine doesn’t spill.

8. If using a mouthpiece, attach the mouthpiece to the front of the nebulizer. The green
exhalation valve on the mouthpiece should be pointing down.
9.
If using a mask, attach the mask with the elbow adaptor to the front of the nebulizer.
10.
Connect the tubing to the bottom of the nebulizer.
11.
Rotate the Mode Selector on the top on the nebulizer to the
breath actuated position. The green button with be in the up
position.
12.
If the mode selector is in the continuous position the green button
will be in the down position.
13.
Turn the compressor on and check the nebulizer for misting.
If the nebulizer is not misting
1. Check all of the connections.
2.
Refer to the manufacturer's instructions.
Taking A Nebulized Treatment Using A Mouthpiece or a Mask
1. Sit comfortably . Position yourself in an upright, sitting position that will allowyou to
take a deep breath.
2.
If using a mouthpiece, put the mouthpiece in your mouth between your teeth
and close your lips around it.
3.
If using a mask, secure the mask on your/your child ’s face and inhale with
your mouth open.
4.
Gently breathe in and out slowly. As you breathe in the green button on top of the
nebulizer will move to the down position. As you breathe out the green button will
move to the up position.
5.
Hold the nebulizer in an upright position . This prevents spilling and promotes
nebulization.
6.
Assure deep breathing throughout the treatment. This allowsthe medication time
to deposit in the airway.
7.
Continue these steps until the onset of inconsistent nebulization, i.e.,
sputtering
.
Care and Cleaning of Nebulizer Equipment After Each Use
Please follow the manufacturer’s instructions for cleaning the nebulizer equipment.
Some suggested guidelines include the following:
1.
Rotate the mode selector to the breath activated position before cleaning (green
button up).
2.
Take apart the nebulizer. Wash all parts (except tubing and mask)in liquid dish soap
and water. Rinse with water.
Or
3.
Place the nebulizer parts (except tubing and mask) in a dishwasher basket and
place on the top rack of the dishwasher.

4. After washing the nebulizer shake off any excess water.
5.
Reattach the nebulizer pieces and tubing to the air compressor and turn on the
compressor to dry the nebulizer quickly.
Make sure the nebulizer is completely
dry before storing the nebulizer.
Care and Cleaning of Nebulizer Equipment Every Other Treatment Day
Disinfect and sterilize your nebulizer also.
Boiling Water
1.
Wash your hands.
2.
Take the nebulizer apart.
3.
Put all the parts except the tubing and mask in boiling water for 10 minutes.
4.
After boiling the nebulizer shake off any excess water and allow to cool.
5.
Reattach the nebulizer pieces and tubing to the air compressor and turn on the
compressor to dry the nebulizer quickly.
Make sure the nebulizer is completely
dry before storing the nebulizer.
The tubing is replaced every two weeks because it isdifficult to clean and dry properly.
Care of the Compressor
Check the manufacturer's instructions for cleaning and care of other compressor you
are using.
Note: This information is provided to you as an educational service of National Jewish
Health.
It is not meant to be a substitute for consulting with your own physician.
©Copyright 2018 National Jewish Health
PTE.376