True EXECUTIVE EZ CHAIR E43500 User manual

Model #: E43500
EXECUTIVE EZ CHAIR
1. To Adjust Seat Height:
While seated, lean forward and reach under the right
side of the chair to find the handle. Lift the handle and
raise your body up slightly to allow the chair to rise to
the desired height. To lower the seat, lift the handle
while applying more weight downward on the seat. The
chair will descend until the handle is released or the
chair reaches the bottom position.
2. To Operate Tilt Lockout:
While seated, reach under the right side of the chair to
find the height adjustment handle. Pull the handle all
the way out (away from the gas lift) to allow the chair to
tilt backwards. To lock the chair in the vertical position,
sit upright and push the handle in towards the gas lift.
3. To Adjust Tension on The Tilt
Mechanism:
Reach under the front center of the chair, grasp the
round knob and turn counter- clockwise to make the tilt
mechanism firmer (stiffer). To make the tilt mechanism
less firm, twist the knob clockwise until the desired
resistance is found.
4. To Disassemble the back cushion:
Remove the black inserts from the top of the arm holes
located on both arm frames. Insert the allen key into
arm hole positions on both sides of the arms and tilt the
back cushion forward. Both pins must be disengaged at
the same time. After it has released from the arms, fold
the back cushion onto the seat cushion.
OPERATING INSTRUCTIONS

Model #: E43500
EXECUTIVE EZ CHAIR
Diagram 1
Part # Description Quantity
1.
2.
3.
4.
5.
6.
7.
8.
9.
Casters
5 Star Base
Telescoping Cover
Gas Lift
Seat Plate
Seat and Back Cushion w/
Arms
2-3/4” Knobs
7/8” Knobs
Allen Keys
5
1
1
1
1
1
2
2
2
A. Remove all parts from carton and separate them into part number groups as indicated in parts list.
B. To begin assembly, place 5 Star Base (2) upside down and insert Casters (1) into bottom of Base (2).
C. Turn Base (2) right side up on the floor and insert Gas Lift (4) into center hole on Base (2).
D. Place Telescoping Cover (3) over the Gas Lift (4) and rest it on the Base (2).
E. Attach the Seat Plate (5) to the bottom of the Seat Cushion (6) (with the front of the seat plate facing the front of seat
cushion). Attach by using 2-3/4” Knobs (7) for the front holes of the Seat Plate (5) and 7/8” Knobs (8) for the rear
holes of the Seat Plate (5). Tighten the knobs completely.
F. Place the pre-assembled Cushions with Arms (6) and Seat Plate (5) on top of Gas Lift (4) and press down until fully
engaged.
G. Standing in front of the chair, push the back cushion into an upright position. Check to make sure the pins have
locked into the arm holes correctly.
H. Periodically (every 90 days) make sure that the screws are still fully tightened.
ATTENTION: Make certain all screws are fully tightened before using chair.
ASSEMBLY INSTRUCTIONS
PARTS LIST