Turbosound iNSPIRE iP2000 User manual

985-40000-00697 Rev.A
2016-09-16 page 1 of 2
Condential, for internal use only. Not to be reproduced.
Service Support
TURBOSOUND iNSPIRE and iX factory reset procedure.
Applicable products:
• iP2000, iP1000, iP500, iP15B, iP12B
• iX15, iX12
Use this procedure if a customer is locked out of the speaker DSP due to forgetting the password.
1. Press and hold down the encoder knob and the SETUP button while powering on the unit.
2. The display screen should now be ashing white and blue.
3. Press the encoder knob twice.
4. You should now see the following screen:
5. Click the 4 buttons:
PROCESS -> SETUP -> EXIT -> ENTER
TURBOSOUND
iNSPIRE and iX Reset

Condential, for internal use only. Not to be reproduced.
MUSIC Group accepts no liability for any loss which may be suered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical specications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. MIDAS, KLARK TEKNIK,
LAB GRUPPEN, LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON, BEHRINGER, BUGERA and DDA are trademarks or registered trademarks of MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2016 All rights reserved.
page 2 of 2
TURBOSOUND
iNSPIRE and iX Reset
6. You should now see the following screen:
7. Press the encoder knob once.
8. You should now see the following screen:
9. Move the encoder knob clockwise and press down once again to complete the factory reset.