Twist EASI-LINK Setup guide

TWIST
EASI-LINK
product set up instructions
19968

Twist Original Setup Instructions
Part 1
1
Warning: Make sure bottom
upright is fully inserted.
!
Items
1x base with rubber grommet; 1x bottom upright section; 1x middle upright section; 1x top upright section; 1x light;
1x transformer; 1x graphic panel with finishing strips.
2
3 4 5
6

Warning: Make sure bottom upright is fully inserted. Twist the upright sections
clockwise to lock, anti-clockwise to open – do not force.
!
Twist Original Setup Instructions
Part 2
7
8
910

Twist Easi-link Setup Instructions
Items
2x linking pins, 3x magnetic bars, complete Twist stands.
Place assembled Twist stands next to each other. Place linking pins in top and bottom finishing strips.
Link the two together and apply magnetic bars to magnetic
tape on reverse of graphic panel.
If graphic requires aligning, stand in front of Twist stands
and place your finger at the bottom of the panel at the join,
lift the lower graphic upwards to align graphics taking any
slack to the top.
1 2
3 4

Twist Easi-link Setup Instructions