Twyford Hydr8 User manual

Hydr
Hydr
8
installation
manual
CURVED &
CURVED &
SAIL PANEL
SAIL PANEL
BATH
BATH
SCREEN
SCREEN
Hydr8 Curved Sail Panel bath scr1 1 06.07.2010 11:07:24

1
IMPORTANT
Please read carefully the following instructions before installing your shower screen to
ensure safe and proper use and avoid any injury to either the installer or user. Before
installing please read also the important instructions. Failure to comply may invalidate
your guarantee.
prior to installation:
Before installing the shower screen, install the bath as per the manufacturers
instructions, making sure that it is level in all directions and that there is a sufficient flat
surface on the top of the bath to fit the screen onto.
curved
panel
sail
panel
Corner Entry Door Components list
No Description Qty
1 glass panel 1
2 outer wall vertical profil 1
3 bottom sealing strip 1
4 Vertical sealing strip 1
5 Fixing cover strip 1
6 Towel bar 1
Bath Scrteen Fixings Pack
Description Qty
Pan hd self tapping screw 30mm ing 4
Plastic wall plugs 4
72 piece corner cover caps 1
Micro adjuster securing clips 3
Hydr8 Curved Sail Panel bath scr2 2 06.07.2010 11:08:29

1
2
3
4
5
2
Drill holes where marked using the 6mm masonry drill bit. (You may need a
specialized drill bit if you are drilling into tiles, if unsure please get advice). You
can now install the wall plugs that have been provided.
!
Postion the wall profile in from the edge of the bath to allow the screen to sit on
the flattest part of the bath rim.
Make sure wall profil is upright using a sprit level.
Mark the position on the wall through the pre drilled holes with your pencil.
Carefully move the wall profile away from the wall and put somewhere safely to
avoid damage when you start drilling.
Screw the wall profile to the wall, using the 30 mm long screws, making sure you
keep the profile vertical.
Hydr8 Curved Sail Panel bath scr3 3 06.07.2010 11:08:30

6
7
8
9
10
4
Push the complete bath screen into the wall profile. Make sure the micro-
adjustment scews are vertical so that they engage into the screen.
Once all of the adjusters are located, turn them to hold and level the
screen onto the bath rim. Finally lock the adjusters with the clips.
Push the alloy fixings cover strip onto its clips.
Install the lower door edge seal ensuring the drip bar faces the inside the bath.
4
Fit the towel rail on the external face of the screen, as shown.
Hydr8 Curved Sail Panel bath scr4 4 06.07.2010 11:08:31

11
12
13
14
15
5
Firstly, fit the wall profile cover cap.
Fit the second cover cap as shown. Then apply the badges as indicated.
Fit the profile cover caps as shown. Then apply the badges as indicated.
5
Using good quality clear silicon sealant, seal the folowing edges:
A: Outside vertical wall-to-frame joint.
B: Inside vertical wall-to-frame joint.
C: Outside horizontal bath-to-frame joint.
Do not seal the inside horizontal bath-to-frame
joint.
Hydr8 Curved Sail Panel bath scr5 5 06.07.2010 11:08:32

Registered office: Lawton Road, Alsager, Stoke-on-Trent, ST7 2DF, UK
T: [phone] F: [phone]
E: [e-mail]
www.twyfordbathrooms.com
Part of the Sanitec Group
Shower enclosures should be cleaned after every use. To prevent limescale from building up, use a squeegee, a
soft cloth or chamois leather - but no cleaning agent - to wipe off any water droplets left after showering. Residue
left by bodycare products (liquid soap, shampoo, shower gel) can also cause substances to accumulate. Use
water to rinse away residues after use. All sliding door track fittings should also be cleaned this way - to ensure
that they continue to run smoothly.
• Don’t allow limescale to build up – especially in hard water areas.
• If you do get a stubborn limescale build up, a mixture of 50:50 vinegar and water will help you to
clean it away – but make sure all vinegar is rinsed off completely.
• Never use strong detergents or cleaning agents.
• Cleaning materials should wherever possible be rated between PH4 and PH8.
• In no circumstances should you use any abrasive substances.
TW H8 006 6-0 Jun2010 FI 24262
Cleaning & Maintenance
Hydr8 Curved Sail Panel bath scr6 6 06.07.2010 11:08:33