PAGE 2 OF 2 0614 IH-1199
ASSEMBLY
GETTING STARTED
1. Remove all components from box.
2. Set Cart Assembly upside down (with open ends
pointing upward).
INSTALLING FRONT CASTERS
Locate front of Cart Assembly.
NOTE: The front of the Cart Assembly is the end
with no handle mounting holes. (See Figure 2)
1. Remove bolt from flat brace on the Cart Assembly
tube side. Loosen other bolt if necessary.
(See Figure 1)
2. Insert 4" Swivel Caster into Cart Assembly tube.
3. Insert bolt through hole and fasten with nut. Tighten
securely.
4. Repeat steps to install remaining Swivel Caster to
other side.
INSTALLING REAR CASTERS
1. Remove bolt from flat brace on the Cart Assembly
tube. Loosen other bolt if necessary.
2. Insert 4" Rigid Caster into Cart Assembly tube.
3. Insert bolt through hole and fasten with nut. Tighten
securely.
4. Repeat steps to install remaining Rigid Caster to
other side.
INSTALL REMAINING PARTS
1. Turn cart upright and attach handle to rear of
mail cart on both sides using bolts and nuts.
(See Figure 2)
2. Place baskets onto the Cart Assembly.
3. Install Guide Rods on upper basket. (See Figure 3)
Cart
Assembly
Tube
Figure 1
Figure 3
Figure 2
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
