Ublox EVK-NINA-W151 User manual

Software installation
The EVK-NINA-W15 software and doc-
umentation is available at www.u-blox.
com/evk-search. Supported Windows
operating systems are Vista, 7, 8, and 10.
1. Download latest s-center software;
run the executable following the
instructions.
2. When the installation is complete,
you will nd the s-center menu under
the Windows Start button,
All Programs > u-blox
3. In the s-center menu, you will nd the
s-center application, user guide and
uninstall options.
Quick Start EVK-NINA-W15
Copyright © 2019, u-blox AGUBX-18063178 - R02
USB connector
NINA-W15
module
U.FL
connector
UART LEDs
Status LED
RESET button
(SW0)
User buttons
(SW1, SW2)

Kit includes
• EVK-NINA-W15 board
• USB cable
• 2.4 GHz external antenna*
• Antenna cable*
* EVK-NINA-W151 only
More information
For more information regarding
EVK-NINA-W15, contact your
nearest u-blox support:
www.u-blox.com/support
Driver installation
1. Connect the EVK-NINA-W15 board to
your PC using the included USB cable.
2. Verify that the USB drivers are in-
stalled successfully.
NOTE: In case the drivers are not in-
stalled automatically, refer to the
EVK-NINA-W15 User Guide.
3. Once the drivers are installed, a COM
port is enabled in Windows. Use the
Windows Device Manager to view the
port number (COM #) for the USB
serial port.
For EVK-NINA-W151 (with external
antenna), attach the antenna to the
antenna cable and connect the antenna
cable to the U.FL connector.
UBX-18063178 - R02