ELECTRICAL (HOUSING)
Input Voltage 24V ac
MECHANICAL (HOUSING)
Angular Travel:
Horizontal ± 180°
Vertical:
Dome 0 to 90° up
Roll 360°
Camera Mounting: Universal mount attached to yoke assembly
will accommodate CS-mount & fixed lens
board cameras
Cable Entry:
Dome Conduit knock-out in standard 4 x 4 in.
electrical box
Cable Connection:
Terminal strip & BNC at top of upper housing
Construction:
Back Can/Box:
Dome Plenum-rated steel (standard 4 x 4 in.
electrical box)
Upper Housing UL-approved, flame-retardant ABS plastic
Lower Housing Optically graded acrylic, distortion free
Finish:
Back Can/Box:
Dome Standard galvanized steel
Lower Housing:
Dome Smoked, clear with liner
Trim Ring White, black
Dimensions See drawings
Weight
Dome 1.0 lb. (w/o 4 x 4 in. back box)
GENERAL (HOUSING)
Optical Losses:
Clear/Liner Virtually no light loss
Smoked Equivalent F-stop 1.0 ± 15%
Filtration Neutral density
Environment Indoor
Regulatory Agencies/
Approvals: CE
ELECTRICAL (CAMERA)
Specification: High Resolution Color
Image Sensor 1/3" interline transfer CCD (Sony chip set)
Active Pixels 768H x 494V
Horiz. Resolution 470 lines
Min Scene Illum. 0.9 Lux (F1.2, 50IRE)
Signal to Noise >45dB (AGC Off)
AGC On/Off selectable
White Balance ATW/AWC selectable
Backlight Comp. Selectable
Auto Iris Video or dc (4-pin connector)
Video Output VBS 1.0Vp-p 75Ω
Power Req. 12V dc ± 10%
Power Consumpt. 190mA
KD5 Series
TECHNICAL SPECIFICATIONS
ELECTRICAL (CAMERA)
Specification: Standard Resolution B&W
Image Sensor 1/3" interline transfer CCD (Sony chip set)
Active Pixels 510H x 492V
Horiz. Resolution 420 lines
Min Scene Illum. 0.2 Lux @ F1.2
Signal to Noise >45dB
AGC On/Off selectable
Backlight Comp. Y selectable
Auto Iris Video or dc (4-pin connector)
Signal Format RS170/EIA
Video Output VBS 1.0Vp-p 75Ω
Power Req. 12V dc ±10%
Power Consumpt. 100mA
MECHANICAL (CAMERA/LENS)
Vari-focal Lens 3.5 to 8.0mm or 5.5 to 33mm
Weight 5.0 oz.
GENERAL (CAMERA/LENS)
Ambient Temp. 32°F to 104°F (0°C to 40°C)
Ambient Humidity 0% to 95% (non-condensing)
5" DOME
FORM 4205 REV 06/19/02 ©Ultrak®is a registered trademark of Ultrak, Inc.2002.
Ultrak Worldwide Support Center:
1305 Waters Ridge Drive
Lewisville, TX 75057
(800) 796-2288 (972) 353-6500
Fax (972) 353-6670
www.ultrak.com
Conversion: 1" = 25.4mm
Measurement conversions are approximate
Design and specifications subject to change without notice.
KD5 Series
Dome Configurator
Part Number: KD5K
24VAC A
In Ceiling 4
Pendant B
Clear 0
Smoked 1
Power Type
C
CAT5Transmission
CAT5 Option
Dome Type
Lower Dome Tint
Lens
Camera
Trim Ring
1
3.5 to 8mm MI Verifocal
A
3.5 to 8mm AI Verifocal
E
5.5 to 33mm MI Verifocal
G
5.5 to 33mm AI Verifocal
1
High Res Color
4
Standard Res B/W
1
WhiteTrim
2
BlackTrim
5" PENDANT