Underground Magnetics Mag 6 Series User manual

www.undergroundmagnetics.co.in
Locator Attributes
Power key: Press and hold to turn on or off
or tap to turn back light on or off
UP key: Move to previous cursor selection
Down key: Move to next cursor selection
Confirm key: Tap to confirm cursor selection.
Press and hold to enter secondary page
Setup key: Tap to enter calibration
page/return to main page; Press and hold to
enter setup page
Menu functions
Transmitter model, operating
frequency and mode
Transmitter temperature (Flashing
indicates transmitter temperature is
rising)
Depth/Slant distance between
transmitter and receiver
Signal to Noise Ratio
Transmitter signal strength
Transmitter pitch
Transmitter battery status
Estimated horizontal distance
between transmitter and receiver
Estimated transmitter depth
Vertical distance between receiver
and transmitter
B1: Transmitter activation
B2: Transmitter pairing
B3: Receiver settings with Transmitter
B4: Telemetry channel selection for receiver
B5: Receiver and display pairing
B6: Roll calibration/offset
B7: Pitch unit selection- Degree/Percentage
B8: Time & Date setting
B9: System lock/unlock
B10: Brightness control
B13: Depth unit selection- Feet/Meter
B16: Speed control of the ball
Getting Started MAG6/MAG8
Reference Booklet - Locator
Transmitter Clock Position

www.undergroundmagnetics.co.in
Transmitter Activation
1.Press and hold to enter setup page.
3.Tap to enter B1 page.
2.Tap to reach B1 icon for transmitter activation.
4. 1040-00601 is the transmitter identification
number and 032583 is the prompt code in the
diagram. Use and to input password in
the 3rd row, tap to confirm activation after
password is entered.
Warning: Transmitter Activation to be completed within 10 minutes
after batteries have been placed in the transmitter.
Note: Send the transmitter identification number and the prompt code
to the dealer. The dealer will give you an activation password.

www.undergroundmagnetics.co.in
Transmitter Selection
1.Press and hold to enter setup page.
Transmitter Setting (Pairing)
1.Press and hold to enter setup page.
2.Tap to reach B3 icon.
3.Tap to enter receiver setting page. Tap or
to reach transmitter model.
Tap to enter Transmitter frequency and Power.
Tap or to set desired frequency and mode.
2.Tap to reach B2 icon.
Warning: Insert the battery inside the transmitter before
proceeding to transmitter setting.
Note: For best results pair the transmitter in all ten frequencies by
repeating the steps in transmitter setting before proceeding to depth
forecast.

www.undergroundmagnetics.co.in
Depth Forecast
1.Tap to enter calibration
page. Tap to reach A5 icon.
3. Tap to enter transmitter settings page. The
receiver and Echo transmitter will automatically pair.
Then tap or and to select its frequency,
power mode and wake up mode.
2.Tap to enter depth prediction page.
Warning: Transmitter should not contain battery while using Depth forecast.
Note: Before proceeding for calibration, please ensure that the surrounding
is free from interference e.g. parks, open area.

www.undergroundmagnetics.co.in
Depth Calibration
1. Ensure that the transmitter is working properly
by verifying the data on receiver and place the
transmitter in the housing.
2. Keep the housing containing the transmitter
away from the interference.
3. Keep the transmitter at 3m/10m/20m (as per
requirement) away from the receiver as shown
in figure.
4.Tap to enter calibration page.
6.Tap two times to start 3m/10/20m calibration
and wait for calibration to complete.
5.Tap or to reach 3m/10/20m calibration
and tap to confirm.
7.Calibration complete.
Warning: Even if the transmitter’s roll, pitch, battery status and temperature
are displayed correctly, calibration may not be reliable due to a distorted
magnetic field.
3m/10m/20m should be
measured from the centre
the housing to centre of the
Locator.

www.undergroundmagnetics.co.in
System Unlock
1.Press and hold to enter setup page.
3.Tap to enter system unlock page.
Tap or and to input password.
.
2.Tap to reach B9 icon.
4.Tap to return to main page.
Note: To get the password
please contact your dealer.
501 & 506, 5th Floor, The Pinnacle Business Tower, Shooting Range Road,
Surajkund, Faridabad, Haryana, India –121009
Ph: [phone]
Email: [e-mail]