Unfinished Furniture of Wilmington CARSON OF-71 User manual

ITEM NO.: OF-71
ISSUED JUL 02, 2021
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: CARSON DESK
: OF-71

ITEM NO.: OF-71
ISSUED JUL 02, 2021
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your table. Protect the surface of the table with cloth if you are using any product
with rubber feet or base.
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OF-71
ISSUED JUL 02, 2021
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Top
1
B
Cross bar
1
C
Base
(L-R)
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Handle
2
2
Pan head screw
(M4 x 22mm)
4
3
Short Bolt
(M8 x 45mm)
6
4
Long Bolt
(M8 x 70mm)
2
5
Lock Washer
(8.5 x13mm)
6
6
Flat Washer
(8.5 x19mm)
6
7
U –Washer
M8
2
8
Screw
(M4 x 35mm)
4
9
Allen Key
(M4 x 30mm x 110mm)
1

ITEM NO.: OF-71
ISSUED JUL 02, 2021
Printed in Vietnam
- 4 -
STEP 1
Attach base (C) to top (A) with bolts (3), and washers (5) and (6) as shown below. Tighten with Allen
key (9).
Attach base (C) to top (A) with screws (8) as shown below. Tighten with a screwdriver.
STEP 2
Insert cross bar (B) into bases (C) and attach with bolts (4) and u-washers (7) as shown below. Tighten
with Allen key (9).
Attach the other base (C) to top (A) with bolts (3), and washers (5) and (6) as shown below. Tighten
with Allen key (9).
Attach the other base (C) to top (A) with screws (8) as shown below. Tighten with a screwdriver.

ITEM NO.: OF-71
ISSUED JUL 02, 2021
Printed in Vietnam
- 5 -
STEP 3
Attach handles (1) to the drawer fronts with pan head screws (2) as shown below. Tighten with a
screwdriver.
Adjust the levelers to the appropriate height to level the desk.