Unfinished Furniture of Wilmington C-20-ARM User manual

ITEM NO.: C-20-ARM
REVISED OCT 30, 2018
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: PAIR OF ARMS FOR C-20 CHAIR
: C-20-ARM

ITEM NO.: C-20-ARM
REVISED OCT 30, 2018
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: C-20-ARM
REVISED OCT 30, 2018
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Arm support
(L-R)
2
B
Arm
(L-R)
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Bolt
(M6 x 90mm)
4
2
Lock Washer
(6.5 x11mm)
8
3
Small Flat Washer
(6.5 x13mm)
4
4
Screw
(M4 x 50 mm)
2
5
Large Flat Washer
(6.5 x19mm)
4
6
Hexagon nut
(M6 x 10mm)
4
7
Allen Key
(M4 x 30mm x 110mm)
1
8
Wrench
(M10 mm)
1
9
Wood plug
(14.5)
4

ITEM NO.: C-20-ARM
REVISED OCT 30, 2018
Printed in Vietnam
- 4 -
STEP 1
Insert arm supports (A) into arms (B) as shown below.
STEP 2
Attach arm supports (A) to seat frame with bolts (1), and washers (2) and (3) as shown below. Tighten
with the Allen key (7).
Then use nuts (6), and washers (2) and (5) as shown below. Tighten with wrench (8).
Attach arms (B) to the chair back with screws (4). Tighten with a screwdriver.

ITEM NO.: C-20-ARM
REVISED OCT 30, 2018
Printed in Vietnam
- 5 -
STEP 3
Then insert wood plugs (9) over bolts to cover them.