Unfinished Furniture of Wilmington LIVE EDGE TRESTLE BENCH BE-7214TA User manual

ITEM NO.: BE-7214TA AND BE-7214TB
REVISED MAY 08, 2017
Printed in Vietnam
THIS ITEM IS PACKED IN TWO CARTONS
- 1 -
Description
Item No.
: LIVE EDGE TRESTLE BENCH
: BE-7214TA AND BE-7214TB
ASSEMBLY INSTRUCTIONS

ITEM NO.: BE-7214TA AND BE-7214TB
REVISED MAY 08, 2017
Printed in Vietnam
THIS ITEM IS PACKED IN TWO CARTONS
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.

ITEM NO.: BE-7214TA AND BE-7214TB
REVISED MAY 08, 2017
Printed in Vietnam
THIS ITEM IS PACKED IN TWO CARTONS
- 3 -
PART LIST BE-7214TA
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Seat
1
B
Crossbar
1
PART LIST BE-7214TB
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
C
Pedestal
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Bolt
(M8 x 35mm)
8
2
Lock washer
(8 x 11mm)
8
3
Flat washer
(8 x 19mm)
8
4
Allen Key
(M4 x 30mm x 110mm)
1
5
Wooden
wedge
2
NOTE: HARDWARE IS PACKED IN CARTON BE-7214TB.

ITEM NO.: BE-7214TA AND BE-7214TB
REVISED MAY 08, 2017
Printed in Vietnam
THIS ITEM IS PACKED IN TWO CARTONS
- 4 -
STEP 1
Attach pedestal (C) to top (A) with bolts (1), and washers (2) and (3) as shown below. Tighten with
Allen key (4).
STEP 2
Insert crossbar (B) into pedestal (C) as shown below.

ITEM NO.: BE-7214TA AND BE-7214TB
REVISED MAY 08, 2017
Printed in Vietnam
THIS ITEM IS PACKED IN TWO CARTONS
- 5 -
STEP 3
Insert crossbar (B) into the other pedestal (C) as shown below.
Then attach pedestal (C) to top (A) with bolts (1), and washers (2) and (3) as shown below. Tighten
with Allen key (4).
Insert wedges (5) into crossbar (B) as shown below.
STEP 4