Unfinished Furniture of Wilmington BE-6015T User manual

ITEM NO.: BE-6015T
ISSUED DEC 08, 2016
Printed in Vietnam
- 1 -
Description
Item No.
: 60 IN CANYON TRESTLE BENCH
: BE-6015T
ASSEMBLY INSTRUCTIONS

ITEM NO.: BE-6015T
ISSUED DEC 08, 2016
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws, bolts until completely assembled.
-Keep all hardware parts out of reach of children.

ITEM NO.: BE-6015T
ISSUED DEC 08, 2016
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Bench top
1
B
Cross bar
1
C
Base
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Short bolt
( M6 x 35mm)
8
2
Long bolt
(M8 x 70mm)
2
3
Lock washer
(6.5 x11mm)
8
4
Flat washer
(6.5 x19mm)
8
5
U –Washer
M8
2
6
Allen Key
(M4 x 30mm x 110mm)
1

ITEM NO.: BE-6015T
ISSUED DEC 08, 2016
Printed in Vietnam
- 4 -
STEP 1
Attach the base (C) to top (A) with bolts (1), and washers (3) and (4) as shown below. Tighten with
Allen key (6).
STEP 2
Attach crossbar (B) to bases (C) with bolts (2), and U-washers (5) as shown below. Tighten with Allen key (6).
Attach the other base (C) to top (A) with bolts (1), and washers (3) and (4) as shown below. Tighten
with Allen key (6).