Unfinished Furniture of Wilmington T-3638DPG User manual

ITEM NO.: T
-
3638DPG
REVISED AUG 27
, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
:
DROPLEAF BISTRO
TABLE
: T-3638DPG

ITEM NO.: T
-
3638DPG
REVISED AUG 27
, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEMB
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
A Leg Lx2pcs
Rx2pcs B Side panel 2
C Shelf 1 D Bottom 1
E Top 1 F Door 2
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: T
-
3638DPG
REVISED AUG 27
, 2014
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Flat washer
( 6.5x16mm) 12
2 Lock washer
(6.5x11mm) 12
3 Short bolt
(M6x40mm) 8
4 Allen key
(M4x80mm) 1
5 Long bolt
(M6x50mm) 4
6 L-Bracket 8
7 Short screw
(M3.5x15mm) 16 8 Long screw (M4x30mm) 6
9 Wood knob
(35mm) 2
10 Pan head screw
(M4x35mm) 2
11 Door pin 4
STEP 1
Attach side panels (B) to legs (A) with bolts (3), and washers (1) and (2). Tighten with the Allen key (4).
Then place the shelf (C) in the unit as shown below.
C
B
B
D
A
A
A
A
4
2
1
3

ITEM NO.: T
-
3638DPG
REVISED AUG 27
, 2014
Printed in Vietnam
- 4 -
STEP 2
Attach the shelf (C) to side panels (B) with L-brackets (6) and screws (7). Tighten with a screwdriver.
Attach the bottom (D) to the sides (B) and legs (A) with L-brackets (6), and screws (7) and (8). Tighten
with a screwdriver.
7
6
67
8
STEP 3
Attach the unit (from step 2) to top (E) with bolts (5), and washers (1) and (2) as shown below. Tighten with
Allen key (4).
E
4
2
1
5

ITEM NO.: T
-
3638DPG
REVISED AUG 27
, 2014
Printed in Vietnam
- 5 -
STEP 4
Attach knobs (9) to doors (F) with bolts (10), as shown below.
STEP 5
Attach doors (F) (from STEP 4) to the unit with door pins (6) as shown below.

ITEM NO.: T
-
3638DPG
REVISED AUG 27
, 2014
Printed in Vietnam
- 6 -
STEP
6
Hold the dropleaf push and slide the wooden piece from underneath the table top . To lower the
dropleaf, carefully hold the dropleaf with one hand and slide the wooden piece from underneath
the table top towards the center of the top. Then, gently lower the leaf and place in the down
position.
STEP 7