Unfinished Furniture of Wilmington T-3662X User manual

ITEM : T-3662X
REVISED APR 02, 2015 Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: 36X48X62 TABLE -SS-LEAF TURNED LEGS
: T-3662X

ITEM : T-3662X
REVISED APR 02, 2015 Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top B
Leg 4
C
Extension
Leaf
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Hexagon nut
(M8 x 13mm)
8
2
Lock washer
(8.5 x 13mm)
8
3
Flat washer
(8.5 x 19mm)
8 4 Wrench
(13mm)
1

ITEM : T-3662X
REVISED APR 02, 2015 Printed in Vietnam
- 3 -
STEP 1
Attach legs (B) to the top (A) with washers (2) and (3), and Hexagon nuts (1) as shown below. Tighten
with the Wrench (4).
STEP 2
Unlock the table top from both sides underneath the top as shown below.
Pull the two parts of the table top apart.

ITEM : T-3662X
REVISED APR 02, 2015 Printed in Vietnam
- 4 -
STEP 3
Place the leaf (C) in the center of the open table top. Push the table top closed. Lock the
mechanism
underneath the table top as shown below.