Unicol NST1 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
NST1 / NST2
Screen Size: 33-90” Guide Max. Weight: 80-150kg

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
1Standard Rhobus Base 1
2Universal Mount Back Plate 1
3Universal Mount Arms 2
4Rhobus Mast (inc. cabinet door) 1
5Manoeuvrability Handle 2
6Security Key 2
#TOOLS REQUIRED
1 Pozi Head Screwdriver
2 5mm Allen Key
3 4mm Allen Key
4 19mm Spanner
5 17mm Spanner
1 2
3
4
5

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
STEP 1
Laying the mast on a flat surface, offer the base
up and attach as shown above. All castors should
already be pre-fixed to the base.
STEP 2
Unlock and lift out rear door. Remove upper rear
panel by unscrewing 4x M6 screws.
STEP 3
Place 2x screws loosely in bottom two rivnuts of
the back plate from rear. Slot into chosen keyholes
in mast. From the rear, screw in top two screws into
the back plate and fully tighten all four screws.
STEP 4
Secure the manoeuvrability handles onto the side
of the mast. From the rear screw into the keyhole
slots and fully tighten. Repeat on the other side.

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 5
Feed cables for screen through hole in backplate
and front of mast and down through cable access.
Refit rear top panel using x4 M6 screws. Refit rear
top panel door and lock.
STEP 6
Locate the mounting holes on the back of your
screen. Line the two mounting arms up and using
the taglocks/two part spacers provided and the
manufacturer recommended screws (not included),
attach the arms to the back of the screen.
STEP 7
Line the screen and arms up with the secured back
plate and offer it up at a slight angle - allowing the
top of the arms to hook over the lip of the back
plate.
STEP 8
Gently lower the screen until the arms are securely
hanging on top of the back plate. Once centered,
adjust the level of the screen with the two top
screws on the mount arms. Once levelled secure
the screen by tightening the bottom two screws.