Unicol ODH User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
ODH
Screen Size: 30-86” Guide Max. Weight: variable

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
2
# DESCRIPTION QTY
1Front Cover and Polycarbonate Screen 1
2ODH Main Body inc. Components 1
3Mount Back Plate 1
4Mounting Arms 2
#TOOLS REQUIRED
1 Pozi Head Screwdriver
2 Security Allen Key
12
3 4
Please Note: Power Cable Not Supplied

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
STEP 1
Remove both front cover retaining screws using the
security allen key.
Please Note: you will need to connect your own
power cable and supply - if unsure please consult a
qualified electrician.
STEP 2
Lift off front cover by unhooking at top.
Separate Main Body from Screen rail by unbolting
transport bolts from screen rail and main body
STEP 3
Using Screen rail mark wall mounting holes in
desired position. Sandwich Main Body between
wall and Screen Rail when fixing to wall.
STEP 4
Locate the mounting holes on the back of your
screen. Line the two mounting arms up (position
arm hooks at the top of the screen) and using
the tag locks and manufacturer recommended
screws supplied in fixing kit, attach the arms to the
back of the screen.

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 5
Using another team member, lift the screen up and
gradually offer it up to the back plate. Double hook
the arms over the lips of the back plate and lower.
Centre the screen horizontally by sliding from side
to side until you are happy with the position.
STEP 6
Utilise the cable entry hole through grommet
located on the bottom of the casing to connect
power source to internal terminal block. Connect
screen and any other device to 2-way socket.
STEP 7
Ensure polycarbonate is positioned within the front
cover and hook front cover back on.
STEP 8
Refit front cover screws.