Unicol ODS DOUBLE SIDED KIOSK User manual

Revised 25/10/19
WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your carrier claims agent and
do not continue the installation until it has been reviewed. Please watch for pinch points. Do not put your fingers between
moveable parts. Do not tamper with or disassemble any spring loaded parts. Before installing, make sure that the supporting
surface will support five times the combined load of the solution and the hardware. Never exceed the maximum load
capacity. Please also layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or personal injury. This
product is intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant or
lifting equipment to lift and position products. For support, please call: [phone].
01865 767676
[email protected]
www.unicol.com
Max Weight:
60kg
ODS DOUBLE SIDED KIOSK
OBELISK DIGITAL SIGNAGE SYSTEM

01865 767676
[email protected]
www.unicol.com
2Revised 25/10/19
TOOLS REQUIRED
4 & 5mm
INSTALLERS REQUIRED
COMPONENTS
# DESCRIPTION QTY
12m Uprights 2
2ODS Freestanding base 1
3Top cover 1
4Bottom cover 1
# DESCRIPTION QTY
5Alternative bolt down base -
6M8x16 Hex head machine screw 2
7M8x20 Hex head machine screw 6
2
34
1
5
13mm
(Preferably ratchet spanner)

01865 767676
[email protected]
www.unicol.com
3
Revised 25/10/19
STEP 3
Gripping the uprights only, lift the screen and lower
over the upright mounts on the base.
Watch out for your cabling - ensure it does not get
pinched in the process.
STEP 1
IMPORTANT:
Screw in M8x16mm hex head screws into top two
fixings in screen - leave at least 2mm gap in order
to slot into uprights
Finger tighten M8x20mm hex head screws into 6
lowest fixings holes to bottom of thread which will
give you the required gap.
STEP 2
Place cables in uprights.
Slot uprights onto screen so that it is flush with
bottom of the cut out within the uprights.
Fully tighten top screws using spanner;
preferably a ratchet spanner. Check all secure.
M8x16mm
M8x16mm
M8x16mm
M8x20mm
STEP 4
Fully tighten grub screws located in upright mounts
on the base.
Cable run

01865 767676
[email protected]
www.unicol.com
4Revised 25/10/19
STEP 7
Locate the top cover and clip into place.
Please note; this is held on magnetically and does
not need screwing into place.
STEP 5
Locate the bottom cover and slide it into position.
The open end should be facing down and the two
small cutouts facing up. This will allow you to slide
over the fixing screws.
STEP 6
Looking underneath the bottom cover, tighten the
two fixing screws. Ensure that the cover is flush
with the bottom of the screen.
75 mm
Drill 11mm Dia hole through
upright inner side
FOR REFERENCE
Upright mount grub screw hole
Note: You can shorten the unit by cutting the up-
rights to the desired height from the bottom. Drill a
new hole to access the base mounting post grub
screw - see Fig A
Fig A