Unicol VERTISLIDE VTS1 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
Screen Size: 40-110”
VTS1 / VTS2
Guide Max. Weight: 60-110kg

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
1VTS Body 1
2VTS Removeable Cassette 1
3VTS Arms 1
4Security Keys 2
5Drawer Handle (pre-attached) 1
#TOOLS REQUIRED
1 Pozi Head Screwdriver
2 17mm Socket Wrench
1 2
4
5
3

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
POSITIONING OF SERVICES
STEP 1
Partially unwind hex head screws to release arms.
Lift off arms and place aside.
STEP 2
Remove x2 M6x12 pozi pan head screws from
handle in transport position (left image).
Screw handle in operational position using same
screws (right image)
STEP 3
Take out removeable cassette and populate with
your media equipment.
Recommended position - either side of the
VTS and behind the screen (size dependant).
Do NOT position services within body of VTS
or within cassette path.
HTS1: 1185x785mm | HTS2: 906x635mm
Additional space for VTS1 only - dependant on
the size of screen (check before installing).

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 4
Position your mount by ensuring that the handle of
the mount will sit just above the edge of the screen
(see below). Once positioned, mark and drill 4x
fixing holes each side. Fix in place using 8x suitable
fixings (not supplied).
STEP 5
Return equipment tray to cassette and cable
up your media equipment using the cable
management system on the side of the mount.
STEP 5
Fix arms to screen. There are two ways of doing
this as shown above. This is dependent on your
screens VESA pattern.
STEP 6
Hook arms onto the mount. Hook on at correct
height so as the handle is always covered by the
screen (as shown above).
edge of screen
Small VESA PatternsLarge VESA Patterns