Unicol RH200HD User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 22/01/21
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
RH200HD
Screen Size: 71-86” Guide Max. Weight: 100kg

01865 767676
[email protected]
www.unicol.com
2Revised 22/01/21
COMPONENTS
INSTALLERS REQUIRED
2
# DESCRIPTION QTY
1Heavy Duty Arms (1x Left, 1x Right) 1
2Universal Mount Arms 4
3Rhobus Mast (inc. cabinet door) 1
5Rhobus Stand Base 1
6Front Fixing Panel 1
7Fixing Kit 1
#TOOLS REQUIRED
1 Pozi Head Screwdriver
2 4mm & 5mm Allen Keys
3 19mm Spanner
4 17mm Spanner
12
3
45

01865 767676
[email protected]
www.unicol.com
3
Revised 22/01/21
STEP 1
Lying the mast on a flat surface, connect base to
mast as shown. The cabinet door side should be
on the rear of the stand. The base should also have
less space at the rear than at the front.
STEP 2
Unlock and lift out rear door. Remove upper rear
panel by unscrewing 4x M6 screws.
STEP 3
Ensuring that the top 4 bolts are half screwed into
position at the top of the mast, take one of the
heavy duty arms and slide the bolts through the key
hole slots and allow the arm to rest on the bolts.
Repeat for the other side.
STEP 4
Before tightening the bolts, take the front fixing
panel and, using the keyhole slots, slide the panel
into position. Tighten the top four bolts.
Fix four bolts into the bottom four holes.

4
01865 767676
[email protected]
www.unicol.com
Revised 22/01/21
STEP 7
Repeat Steps 6 & 7 for the second screen.
Adjust the level of the screen with the two top
screws on the mount arms. Once levelled secure
the screen by tightening the bottom two screws.
STEP 8
Feed cables for screen through hole in backplate
and front of mast and down through the mast and
out through the bottom of the mast/base.
Refit rear top panel using x4 M6 screws. Refit rear
door and lock.
STEP 5
Locate the mounting holes on the back of your
screen. Line the two mounting arms up and using
the taglocks/two part spacers provided and the
manufacturer recommended screws, attach the
arms to the back of the screen.
STEP 6
Line the screen and arms up with the secured
heavy duty arms and offer it up at a slight angle -
allowing the top of the mount arms to hook over
the lip of the heavy duty arms.