Uniden G101 User manual

1
◆ This unit, if not installed properly, maybe defective.
◆ This camera is powered by AA batteries only. Do not use any power
adaptor.
◆ When installing batteries (not supplied), please ensure that they are
inserted with proper orientation.
◆ Do not expose the insides of the unit to rain or moisture.
◆ If any items are missing or damaged, contact your place of purchase
immediately. Never use damaged products!
◆ Need help? Get answers at our website:
www.uniden.com.au for Australian model
www.uniden.co.nz for New Zealand model.
QUICK START GUIDE
#Once the batteries have been installed, the LEDs will blink at an
interval of 2 seconds.
SAFETY INSTRUCTIONS
Camera Base
LED Light
Camera Lens
G101 - DOME IMITATION CAMERA

2
To install the batteries (not supplied), open the casing (found at the base)
and then insert three AA batteries with proper orientation.
1. Use the included guide card to mark the place to install and screw the
camera.
2. Drill necessary holes in the marked spots.
3. Place the included anchors into the drilled spots.
4. Use the anchors to hold the screws, and ensure that the screws stay out a
bit to hold the camera.
Place the camera on the selected spot
to match the mounting holes with
the screws and turn it to the right
to fix it.
SPECIFICATIONS
INSTALLATION
Material ABS
Colour White
Camera Base ABS
Camera Lens Plastic
Power Source 3 x 1.5V AA batteries
On/Off Method Installation/Removal of batteries
Accessories Mounting Hardware, 2 Screws
Unit N.W 130g

3
ONE-YEAR LIMITED WARRANTY
Terms of Warranty: Uniden Aust/NZ warrants to the original retail
purchaser only that the G101 (“the Product”), will be free from defects
in materials and craftsmanship for the duration of the warranty
period, subject to the limitations and exclusions set out below.
Warranty Period: This warranty to the original retail purchaser is only
valid in the original country of purchase for a Product first purchased
either in Australia or New Zealand and will expire one (1) year from the
date of the original retail sale. If a warranty claim is made, this warranty
will not apply if the Product is found by Uniden to be:
A. Damaged or not maintained in a reasonable manner or as recommended
in the relevant Uniden Owner’s Manual;
B. Modified, altered or used as part of any conversion kits, subassemblies or
any configurations not sold by Uniden Aust or Uniden NZ;
C. Improperly installed contrary to instructions contained in the relevant
Owner’s Manual
D. Repaired by someone other than an authorized Uniden Repair Agent in
relation to a defect or malfunction covered by this warranty; or
E. Used in conjunction with any equipment, parts or a system
notmanufactured by Uniden.
Parts Covered: This warranty covers the Product and included
accessories.
User-generated Data: This warranty does not cover any claimed loss of
or damage to user-generated data (including but without limitation phone
numbers, addresses and images)that may be stored on your Product.
Satisfactory evidence of the original purchase is required for warranty
service. Please refer to our Uniden website for any details or warranty
durations offered in addition to those contained below.
The warrantor is either Uniden Australia Pty Limited ABN 58 001 865 498
(“Uniden Aust”) or Uniden New Zealand Limited (“Uniden NZ”) as the
case maybe.
UNIDEN G101 Dome Imitation Camera
Important:
Warrantor:

4
Statement of Remedy: If the Product is found not to conform to this
warranty as stated above, the Warrantor, at its discretion, will either
repair the defect or replace the Product without any charge for parts or
service. This warranty does not include any reimbursement or payment
of any consequential damages claimed to arise from a Product’s failure to
comply with the warranty. Our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure. This warranty is in addition
to and sits alongside your rights under either the COMPETITION AND
CONSUMER ACT 2010 (Australia) or the CONSUMER GUARANTEES
ACT (New Zealand) as the case may be, none of which can be excluded.
Procedure for Obtaining Warranty Service: Depending on the
country in which the Product was first purchased, if you believe that
your Product does not conform with this warranty, you should deliver
the Product, together with satisfactory evidence of your original
purchase (such as a legible copy of the sales docket) to Uniden at the
addresses shown below. You should contact Uniden regarding any
compensation that may be payable for your expenses incurred in making
a warranty claim. Prior to delivery, we recommend that you make a
backup copy of any phone numbers, images or other data stored on
your Product, in case it is lost or damaged during warranty service.
UNIDEN AUSTRALIA PTY LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Phone number: 1300 366 895
Email: [email protected]
UNIDEN NEW ZEALAND LTD
Service Division
150 Harris Road, East Tamaki
Auckland 2013
Phone number: [phone]
Email: [email protected]