UNION GLASHÜTTE/SA UNG-27.S2 User manual

TECHNICAL SPECIFICATIONS
• Mechanical movement chronograph UNG-27.S2 with
automatic winding and date corrector at 10 o’clock
• Number of jewels: 29
• 28,800 vibrations/hour
• Power reserve:Approx 65 hours
DISPLAY / FUNCTIONS
1 Hour hand
2 Minute hand
3 Small seconds hand
4 Date indicator
5 Corrector (rapid date correction)
6 Central 60 seconds hand (chronograph)
7 30 minute counter (chronograph)
8 Start/Stop push-button (chronograph)
9 Reset push-button (chronograph)
10 2 position crown*
I Rest and winding position
II Time setting position, with stop second
and midnight date and day chang
* In models from the „Sport“ series, the crown is also screwed to the
case to ensure increased water resistance.To operate the crown, turn it
counterclockwise until it pops out clearly through the built-in spring. To
screw the crown back on, press it slightly towards the case and turn it
clockwise until it stops. Do not operate the crown under water.
UNG-27.S2
USER’S MANUAL
1/2WWW.UNION-GLASHUETTE.COM UNG-27.S2_E / 2023

UNG-27.S2
USE
WINDING
Crown in position I, not pulled out
Manual winding is necessary if you have not worn your
watch for some considerable period of time. To restart
it, you only need to turn the crown a few times (clo-
ckwise), or to tilt your watch from side to side a few times.
To restore your watch’s 65 hours power reserve, around
45 turns of the crown (forward) are required.
When wearing your watch, the automatic device winds it
every time you move your wrist.
Notes
The accuracy may be inuenced by the wearing conditions.
There is no stop of the crown at full winding
SETTING THE TIME
Crown in position II, pulled out
Pull the crown out to position II carefully; the seconds
hand (3) will stop.Turn the crown forwards or backwards
to set the desired time, and then push it back into the rest
position I.
Once the hour hand passes the 12 o’clock position, you
can see if it is indicating midnight (date will change) or
midday (date will not change
ADVICE ON HOW TO SYNCHRONISE YOUR WATCH
To synchronise the seconds hand (3) with an ofcial time
signal (radio/TV/Internet), pull out the crown to position
II; the seconds hand will stop.At the signal, push the crown
back into the rest position I.
RAPID DATE CORRECTION
Press the corrector as many time as needed (5), to move
the disc forward until the desired date (4) is displayed. Dur-
ing this operation, your watch will continue running, so the
time will not need to be re-set.
Important: Rapid date correction is impossible
between 8.30 p.m. and 11.30 p.m.
CHRONOGRAPH FUNCTION
Press the Start/Stop push-button (8) to start the chrono-
graph. Press the Start/Stop push-button (8) again to stop it.
The chronograph will resume if the Start/Stop push-button
(8) is pressed again (added times), or the two chronograph
hands (6and 7) will return to zero if push-button (9) is
pressed.
CARE AND MAINTENANCE
We would advise you to clean your watch regularly
(except for the leather strap) using a soft cloth and luke-
warm soapy water. After immersion in salt water, rinse the
watch in fresh water and leave it to dry completely.
Ensure that you do not leave it in places subject to great
temperature and humidity variations, in intense sunlight or
near strong magnetic elds.
We recommend you have your watch inspected every 3
to 4 years by your approved dealer or agent. For an irre-
proachable maintenance service and to ensure the war-
ranty remains valid, always approach an approved dealer
or agent.
WATER RESISTANCE PRECAUTIONS
Your watch is water resistant but, following a shock, it may
lose its water resistance without you realising.Water resist-
ance must be checked up during its scheduled inspection.
Important: In the event of failure of your watch,
entrust it only to an approved dealer or agent (see
the warranty).
2/2WWW.UNION-GLASHUETTE.COM UNG-27.S2_E / 2023