
UNG-58.S1
USE
WINDING
Crown in position I, not pulled out
Your model has a manual winding movement. If, after having
fully wound the watch, you do not wear it for longer than
60 hours, it will stop.You must rewind it by hand to get
it moving again.To do this, turn the crown in a clockwise
direction. The balance will begin to move after a few turns.
Continue to turn the winding mechanism until it cannot be
wound up anymore (about 38 times). Please do not wind it
up too tightly to avoid damaging the clockwork mechanism.
For daily use, we recommend that you wind the watch in
the morning before you put it on.The movement spring
then has enough power reserve to keep your watch
running smoothly until the next day and beyond.
Notes
The accuracy may be inuenced by the wearing conditions.
There is no stop of the crown at full winding.
SETTING THE TIME
Crown in position III, pulled out
Pull the crown out to position III carefully; the seconds
hand (3) will stop.Turn the crown forwards or backwards
to the desired time, and then push it back into the rest
position I.
Once the hour hand passes the 12 o’clock position, you
can see if it is indicating midnight (date and day will change)
or midday (date and day will not change).
Advice on how to synchronise your watch
To synchronise the seconds hand (3) with an ofcial time
signal (radio/TV/Internet), pull out the crown to position
III ; the seconds hand will stop.At the signal, push the crown
back into the rest position I.
DATE AND MONTH CORRECTION
Crown in position II, intermediate
The date is indicated by the hand (5) and the month in the
aperture (7).You will need to re-set the date and month
manually after months with less than 31 days.
Pull the crown out to position II and turn it counterclockwise
until it displays the desired date and month. Push the
crown back into the rest position I. During this operation,
your watch will continue running, so the time will not need
to be re-set.
Important: Never correct the date between 10 p.m.
and 2 a.m.; the movement is changing the date and
possibly the month.
MOON PHASE CORRECTION
Crown in position II, intermediate
Pull the crown out to position II and turn it clockwise
to correct the moon position, referring to a lunar phase
chart. Push the crown back into the rest position I. During
this operation, your watch will continue running, so the
time will not need to be re-set.
Important: Moon phase correction is impossible
between 3 a.m. and 4 a.m.
DAY CORRECTION
Press the corrector as many time as needed (10), to
move the disc forward until the desired day is displayed
in the aperture (6). During this operation, your watch will
continue running, so the time will not need to be re-set.
Important: Day correction is impossible between
9.30 p.m. and midnight.
CARE AND MAINTENANCE
We would advise you to clean your watch regularly (except
for the leather strap) using a soft cloth and lukewarm soapy
water. After immersion in salt water, rinse your watch in
fresh water and leave it to dry completely.
Ensure that you do not leave it in places subject to great
temperature and humidity variations, in intense sunlight or
near strong magnetic elds.
We recommend you have your watch inspected every
3 to 4 years by your approved dealer or agent. For an
irreproachable maintenance service and to ensure the
warranty remains valid, always approach an approved
dealer or agent.
WATER RESISTANCE PRECAUTIONS
Your watch is water resistant but, following a shock, it
may lose its water resistance without you realising. Water
resistance must be checked up during its scheduled
inspection.
Important: In the event of failure of your watch,
entrust it only to an approved dealer or agent (see
the warranty).
2/2
UNG-58.S1_EN / 2019
WWW.UNION-GLASHUETTE.COM