Unitech MS920P User manual

MS920P Quick Start Guide
The Unitech MS920P 2D Pocket Scanner 1. Flip the rubber cover up to expose the micro USB port on the scanner.
2. Plug the micro USB cable into the port on the scanner and into a free USB port of a host computer.
Charge for 4 hours.
Step 1:
connect and Charge
Test & Finish
Step 5:
Open a word processing program or app such as
Microsoft Word or Notepad on your host device.
Now scan the following barcode:
If the word “Unitech” appears on the screen
you have succesfully connected your scanner.
Congratulations!
Silence
Silence off * Silence on
silence MS920P TIPS
• The MS920P should be recognized as a generic HID device
by your host device, similar to a standard keyboard. This
allows you to scan into any field you could normally type into.
• If the MS920P is out of RF transmitting range from the host
device, it will automatically save any scan data in its buffer
memory and automatically upload the scan data to the host
when back in RF transmitting range.
• The MS920P can also operate in Batch Mode, where a
RF transmitting connection is not required. In Batch Mode,
the MS920P saves all scan data in internal memory and then
uploads the data when connected to a host. See back page
of this guide for more information about modes and settings.
RF HID *
COmmunication mode
RF SPP USB
MicroUSB
Plug the USB Dongle to a free USB port of
a host computer.
The MS920P is now ready to use.
Scan the barcode on the USB Dongle.
Connect dongle to host
Step 4:
Scan Dongle
Step 3:
COmmunication mode COmmunication mode

All-Purpose Pocket Scanner Memory Pocket Scanner 2d Pocket Scanner
mugfokcapafoeziS•
,SOihtiwelbitapmochtooteulB•
Android, Windows
yromemBM2•
gninnacshctaBdnaotuA•
sedocrabD2/D1sdaeR•
yromemBM2•
laeslatnemnorivne24PI•
Try a Unitech
wireless pocket scanner
for your smartphone,
tablet, or computer
MS920p Quick Start Guide
Scan here to send data from the MS920P to your
host device after collecting the data in Batch Mode.
Scan here to unpair the RF connection
between the MS920P and the host device.
Scan here to switch from Auto Mode to Batch Mode.
Data will now be stored in the internal memory of
the MS920P and the MS920P will no longer transmit
data via RF.
Scan here to switch back to Auto Mode.
You can now pair the MS920P with a host.
Scan these barcodes if you wish to erase the data
stored on your MS920P. Please keep in mind that
this process is irreversible.
Scan these barcodes if you wish to erase the data
stored in the MS920P’s buffer memory.
This factory default barcode will return your
scanner to its original factory settings, a useful
feature for troubleshooting purposes.
Switch to Batch mode
switch to auto Mode ( Default )
Volume
DELETE DATA ( Batch mode )
RESTORE FACTORY DEFAULT SETTINGS
TRANSFER DATA
DISCONNECT PAIRING
Enable Batch Mode Transfer Data
1
2
Enable Auto Mode Disconnect Pairing
Factory Default
vibration
Vibration on/off
. They are optional.
© 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
display f/w version
RF Module Power Saving
DELETE DATA ( auto mode )
1
2
Volume Up
Volume Down
P
Display F/W Version 1 Minute 3 Minute 5 Minute Never