Unitech EA520 User manual

EA520 4-Slot Terminal Cradle
Quick Start Guide
V1.0
Package
Please make sure the following contents are in the
EA520 4-Slot terminal cradle gift box.
If something is missing or damaged, please contact
your Unitech representative.
The Package Contents
Optional Accessories
LED Indicator Status
Cradle Power LED
LED Status Description
Solid Green Light Power supply is
connected.
LED Off Power supply is not
connected.
Note: When EA520 is inserted in the cradle,
the LED indicator on the cradle will not be changed.
For charging status, see LED on EA520.
LED Status Description
Solid Red Light Charging
Solid Green Light Charging completed.
EA520 LED
Charging the Battery
Plug the AC adapter cable into the power jack
on the battery charger, and then plug the other
end of the AC adapter into an electrical outlet.
Put EA520 into the cradle following the picture
below.
• EA520 4-slot Terminal Charging Cradle
• Default detachable cover on the cradle for
EA520 without boot case*4
• 12VDC 5A power supply (#1010-900068G)
• 3 Pins Power Cord (US)
• 3 Pins Power Cord (EU)
• 3 Pins Power Cord (UK)

How to Re
To ensure the unit working properly, please keep all connectors away
from the contaminants such as dust, grease, mud, and water.
Negligence may cause the unit to lose communication, short circuit, or
overheated. If the connector is damaged, please ensure the connector
is fully repaired before using the unit to avoid short circuit.
WARNING!
There is a risk of fire and burns if the battery is handled improperly.
DO NOT disassemble, crush, puncture, short external contacts,
or dispose the battery pack in fire or water.
DO NOT attempt to open or service the battery.
Dispose used batteries according to local recycling guidelines in your area.
CAUTION!
Copyright 2022 unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
http://www.ute.com/
The detachable cover How to Remove the Detachable Cover
Note: Please remove the detachable cover
while charging EA520 with boot case on.
1. Grab the two top edges of the detachable
cover and bent inward then lift to remove.
Insert the detachable cover into the cradle.
Make sure the arrows of the cover matches with
the cradle (Please refer to the picture below).
How to Insert the Detachable Cover