© United Products 2017
Designed in Australia
01 02 03
04 05 06
Installation Manual
Installation Instructions - if you have any doubts please contact us: hello@united-products.co
01. Position basin. Minimum 20mm from finished wall out line waste position on floor or wall. Verify integrity of floor surface and
plumbing is in appropriate position for basin installation.
02. Position mounting plate on finished floor surface, minimum recommended centre 295mm from finished wall and
outline hole position. Drill holes and use appropriate fixings for the floor and sub-straight. Bolt mounting plate to floor using
mould resistant silicon adhesive. Ensure mounting plate is level.
03. Install waste specified for the basin
04. Invert basin, confirm surfaces are clean and dry. Apply anti fungal silicone adhesive. Place basin in position aligning waste.
Ensure basin is level.
05. Allow silicone to cure. Ensure basin is level. Connect basin to waste.
06. Clean with a soapy sponge, followed by a rinse. For stubborn stains such as lime scale or soap build up
use a mild abrasive cleaner like Gumption®paste, Jif® cream or Ajax® cream or powder - use with a soft damp cloth
in wide circular motions. ENJOY
Siren Pedestal Basin 1 005 001
565 mm
