Universal Furniture Explore Home Allure 956813 User manual

Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts
that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
INSTRUCTION SHEET
PARTS LIST:
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Assembly is now Complete
# Description QTY
A
C
Leg
Desk Top
1PC
1PC
Step 2: Screw bottom rails F to the leg A by allen wrench and screw stretcher E to the leg A and B by
956813
Step 3: Screw the base to the Desk Top C by allen wrench, make sure to screw it tightly.
# Description QTY
DGlass 1PC
Stretcher
E1PC
1PC
Bottom rails
F
Page 1 of 2
Step 4: Put the glass D on the desk.
BLeg 1PC
allen wrench, make sure screw them tightly.
Allure Vanity Desk

HARDWARE LIST(F) Q'TY
14PCS
INSTRUCTION SHEET
26PCS Bolt
3
956813
4 Allen Wrench 1PC
Bolt
Bolt 4PCS
Screw 10PCS
5
adjustable Leveler
Ø1/4"*1-2"
Ø1/4"*1"
Ø1/4"*5/8"
4mm
#8*7/8''
Page 2 of 2
Allure Vanity Desk