1
VG-6734 Conventional Sounder Strobe
V-GREAT GLOBAL CORPORATION
Installation and Operation Manual V1.06
Features
Providing 16 tones.
Using ultra bright LEDs as source for light indication.
Standard: EN 54-3.
Not approved to EN 54-23.
Description
VG-6734 Conventional Sounder Strobe is an audible and
visual combined warning device used to warn people in
field when fire occurs. It can give audible and visual
alarm signal.
Connection & Cabling
Terminals on the base are shown in Fig.2.
Fig. 1 Fig. 2
1-positive，5-negative，connected with sounder output on panel.
Recommended Wiring
1.5mm2or above fire cable for 24VDC power line, subject to local codes.
Installation
the sounder strobe can be mounted on the back
box. The mounting hole spacing and mounting
direction are shown in Fig. 2.Mounting method is
shown in Fig. 3.
The base and the sounder strobe are twisted
together. When mounting, remove the sounder
strobe, thread cables through the cable entry in the
base and connect with corresponding terminals,
then twist the sounder strobe onto the base.
If the sounder strobe is required to be tamper-proof,
knock down the arch knockout as shown in Fig. 1
and fix it with ST2.9×6.5 self- tapping screws (in
this case, it can only be removed by a cross
screwdriver).
Conduit
Back Box
Sounder Strobe
1174c/01
E
R
T
I
F
I
C
A
T
I
O
N
B
O
A
R
D
L
O
S
S
P
R
E
V
E
N
T
I
O
N
C
L
PCB
2831-CPR-F1544
19
