V-tech Kidi DJ MIX Assembly Instructions

Parent’s Guide
91-004004-001 UK

2
INTRODUCTION
Thank you for purchasing Kidi DJ Mix. Get in the DJ booth and
create your own custom music mixes! Customise the 15 included
songs or play along with your own music (external music player not
included). Jam, scratch and mix it up – you’re the star!
1
1
2
4
5
6
7
8
12
13
14
15
16
3
9
10
11
17
18
2
19
9
3
20
4
12
21 22 23
5
13
10
11
14
15
16
17
6
7
8
18
Vocal Track Button
Bluetooth®Connect Button
Audio-Out Jack
Mode Buttons
Style Button
Microphone
Selection Buttons
(Left, Right, OK)
Line-In Button
Power Button
Line-In Jack
Launch Pads
Custom Sound Effects Buttons
Pause Button
Bluetooth®Input Button
Turntable
20
21
22
23
19
Volume Control
Party Light On/Off Switch
Crossfader
Party Light Mode Button
Tempo Buttons
AC Adapter Jack
Preset SFX Buttons
Turntable Effect Buttons

3
INCLUDED IN THE PACKAGE
• Kidi DJ Mix
• Parent’s Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please keep this parent’s guide as it contains important information.
Removing the Packaging Locks
Rotate the packaging locks 90 degrees
anticlockwise.
Pull out the packaging locks.

4
GETTING STARTED
NOTE
This product is in Try-me mode in the packaging. In DJ Party
mode , press and hold Custom Sound Effect Button
#5 for three seconds to exit Try-Me mode. If the unit powers
down during play, please install a new set of batteries.
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw and
then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 4 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

5
BATTERY NOTICE
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

7
POWER ADAPTER CONNECTION
• Make sure your Kidi DJ Mix is turned off.
• Locate the AC Adapter Jack on the side of the unit.
• Connect an AC adapter (not included) to the AC Adapter Jack.
• Plug the adapter into a power outlet.
• Press the Power Button to turn the system On.
Note: When the toy is not going to be used for an extended period of
time, unplug the adapter.
Safety information when using power
supply for toys
VTech recommend a power supply (AC/DC adaptor) of the below
specication:
Power rating: 6V/800mA DC output with 3.5mm plug (positive centre).
• This toy shall only be used with a power supply for toys.
• The power supply is not a toy.
• This toy is not intended for use by children under 3 years old.
• Do not connect the toy to more than the recommended number of
power supplies.
• Never clean a plugged in toy with liquid.
• Please examine the power supply periodically for conditions that
mayresultintheriskofre,electricshock,orinjurytopersons
(such as damage to the supply cord, output cord, plug, blades,
housing, or other parts) and that, in the event of such conditions,
the power supply should be scrapped.
• Power supplies for toys are not intended to be used as toys,
and the use of these products by children shall be under the full
supervision of parents.

8
PRODUCT FEATURES
1. Power Button
Press the Power Button to power
On the unit. Press the button again to
power Off the unit.
2. Line-In Jack
Connect an external music player here
using a 3.5mm cable (cable and music
player not included).
3. Audio-Out Jack
Connect the mixer to external
speakers or headphones using the
Audio-Out Jack (cable not included).
4. AC Adapter
Connect the mixer to AC power
(adapter not included).
5. Automatic Shut-Off
To preserve battery life, Kidi DJ Mix will automatically turn off
after 10 minutes without input. The unit can be turned on again by
pressing the Power Button.

9
Modes
DJ Party
Create custom mixes with any of the
15built-intracks,adjustingallaspects
of each song, or play along with your
own music.
Audio Controls
• Use the Launch Pads to choose
different instruments to play. Each
column triggers one instrument at a time.
• Press the Preset Sound Effects
Buttons to play built-in sound effects.
• Press the Style Button to change the
track’s style. The Launch Pads and
Preset Sound Effects Buttons will
adjustwhattheyplayaccordingly.

10
• Press and hold any of the Custom
Sound Effect Buttons to record your
own short sound effect and assign
ittooneofthevebuttons.When
the button lights up, it is recording.
Release the button when you’re
nishedrecording.Pressthebutton
again to hear your custom sound effect.
• Scratch the Turntable back and
forth to add scratching effects to your
music. Press a Turntable Effect
Button to change the sound effect the
turntable makes.
• Press the Vocal Track Button to add
or remove singing from the mix for all
built-in songs.
• Press the Line-In Button to play audio
from a device plugged in to the Line-In
Jack (external music player and cable
not included).

11
• Press the Bluetooth®Connect
Button to connect to a nearby device
via Bluetooth®connection. Once the
device is paired, press the Bluetooth®
Input Button to choose this as the
audio input source.
NOTE
If your music device does not support a PIN code connection, you
can disable the PIN by pressing the selection buttons.
Please use the PIN-secured connection when possible. VTech®
strongly recommends keeping the PIN security on for the
use of Bluetooth®transmission to avoid any connection by an
unauthorized device. The disabling of the PIN security should
only be used when the connection of an external device with
PIN security is impossible. The use of the toy when PIN security
has been disabled should be under the supervision of an adult.
• Use the Crossfadertoadjustthe
volume balance between your selected
audio source and the system’s built-in
sounds.
NOTE
When playing audio wirelessly through the system, we suggest
youonlyadjustyoursmartdevice’svolumeusingtheCrossfader
on the Kidi DJ Mix system. For best performance, set your
device’s volume to 100% with the Crossfader in the middle
position to get started.

12
• Use the Tempo Control Buttons
toadjustthetempoofbuilt-inaudio
tracks.
• Press the Pause Button to pause or
resume the music.
• Use the Volume Control Slider to
adjusttheoverallsystemvolume.
Party Light Control
Use the Party Light On/Off Button to
switch the light on or off.

13
Studio
In Studio mode you can either record
or play back tracks using the Left,
Right, and OK Buttons.
Record
Press the OK Button to enter record
mode and select one of the three slots
you would like to save your mix. After
a countdown, recording will begin.
The system will record the sound from
the Turntable, Vocal Track, Launch
Pads, preset and custom sound
effects (see note below), Crossfader actions and tempo changes.
Whenyounishrecording,presstheOK Button to save your mix.
NOTE
If you create new custom sound effects at a later time, when you
play back tracks recorded earlier, any custom sound effects in the
original recordings will trigger the system’s current custom effects.
Playback
Choose the track you would like to play with the Left, Right and
OK Buttons.

14
Academy
See how well you can repeat the patterns. When you play back a
rhythm with 75% or more notes correct, your score at the top of
the screen will increase. The patterns include the Crossfader and
Turntable controls as well: watch the screen to see when they’re
indicated. A total of 11 patterns will appear in each game. Get
nine or more patterns correct to unlock secret animations.
Score bar
Turntable
indicator Crossfader
indicator

15
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat source.
3. Remove the batteries when the unit will not be in use for an
extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play with again.
5. If the unit still does not work, install a brand new set of batteries.
If the problem persists, please contact our Consumer Services
Department and a service representative will be happy to help you.

16
Bluetooth®Statement
The Bluetooth®word mark and logos are registered trademarks
owned by the Bluetooth SIG, Inc. and any use of such marks by
VTech®is under license. Other trademarks and trade names are
those of their respective owners.
DECLARATION OF CONFORMITY
Hereby, VTech Electronics Europe BV declares that the radio
equipment type 5473 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address:
www.vtech.com/re-directive
Frequency Band: 2402MHz – 2480MHz
Maximum RF power: 1.6mW (2dBm)
DECLARATION OF CONFORMITY
Hereby, VTech Electronics Europe Plc (UK) declares that the radio
equipment type 5473 is in compliance with The Radio Equipment
Regulations 2017 (2017 No.1206). The full text of the Declaration of
conformity is available at the following internet address:
www.vtech.com/re-directive
Frequency Band: 2402MHz – 2480MHz
Maximum RF power: 1.6mW (2dBm)
Player
Maximum output voltage ≤150mV

17
CONSUMER SERVICES
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make
every effort to ensure the accuracy of the information, which forms
the value of our products. However, errors sometimes can occur.
It is important for you to know that we stand behind our products
and encourage you to call our Consumer Services Department with
any problems and/or suggestions that you might have. A service
representative will be happy to help you.
UK Customers:
Phone: [phone] (from UK) or [phone] (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: [phone]
Website: support.vtech.com.au
NZ Customers:
Phone: [phone]
Website: support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER
GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees
apply to goods and services supplied by VTech Electronics (Australia)
Pty Limited. Please refer to vtech.com.au/consumerguarantees for
further information.

Visit our website for more
information about our products,
downloads, resources and more.
www.vtech.co.uk
www.vtech.com.au
TM & © 2021 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-004004-001 UK