V-tech Launch & Chase Police Tower User manual

User’s Manual
91-003514-000
Launch & Chase Police TowerTM

2
2
2
5 SmartPoint®
Locations
2 Launchers
Jail
SmartPoint®
Police Car
Getaway Car
INTRODUCTION
Thank you for purchasing the Go! Go! Smart Wheels®Launch &
Chase Police Tower™by VTech® ! Watch the Police Car come to life
when you race him around the course and over the five SmartPoint®
locations. Have fun on the chase and catch the Getaway Car!

3
3
3
INCLUDED IN THIS PACKAGE
Getaway Car
Base
Jail base Jail wall Fuel pump
Track 1
Track 2 Track 3 Track 4
Ramp support
Dual tower
SmartPoint®
Police Car

4
4
4
Track 5
Track 8
Gate Track sign Launcher 1
Launcher 2 Launcher 1 support Launcher 2 support
Track 9 Two roadblocks
Track 6 Track 7

5
5
5
Hideout
Police station wall
- One label sheet
- One parent’s guide
Fuel platform
Hideout base Police station base

6
6
6
WARNING:
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties and packaging screws are not
part of this toy, and should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains important
information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE : Il est conseillé de conserver ce guide des parents car il
comporte des informations importantes.
Adult assembly required.
Ce jouet doit être assemblé par un adulte.
Unlock the packaging locks:
Turn the packaging lock counterclockwise
several times.
Pull out and discard the packaging lock.

7
7
7
GETTING STARTED
BATTERY INSTALLATION
Police Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the Police Car. Use a coin
or screwdriver to loosen the screw.
3. Install two new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.

8
8
8
Please adhere the labels to the playset
securely as indicated on the following pages
below:
13
19
16
11
7
2
17
13
4568
12 14
15
10
18
9

9
9
9
13
19 19
16
11
7
2
17
1
3
4
5
6
8
12
14
15
10
9
18

10
10
10
ASSEMBLY INSTRUCTIONS
Launch & Chase Police Tower™
With the VTech®Go! Go! Smart Wheels®Launch & Chase Police
Tower™, safety comes first.To ensure your child’s safety, adult
assemblyisrequired.
1. Insert both the Ramp Support and the Jail Wall into the Jail Base,
as shown below.
2. Connect the Jail Base and Fuel Platform to the Base,as shown
below.
3. Insert the Fuel Pump and Dual Tower into the slots on the Base, 
as shown below.

11
11
11
4. Insert the Police Station Wall into the Police Station Base and
the Hideout into the the Hideout Base.Then,connectthebases
to the Dual Tower,asshownbelow.
5. Attach Track 9 to the Dual Tower,asshownbelow.
6. Attach Track 2 to the Dual Tower, as shown below.
7. Attach Track 1 to the Ramp Support and Track 2,asshownbelow.

12
12
12
8. Connect Track 3 to Track 2 and the Dual Tower,asshownbelow.
9. Insert the two Roadblocks and Gate into Track 4,asshownbelow.
10. Connect Track 4 to Track 9 and Ramp Support.Then, attach
Track 3 to Track 4,asshownbelow.

13
13
13
11. Connect Track 5 to Track 4 and the Dual Tower, as shown below.
12. Attach Track 5 to Track 6.Then,insertTrack 6 into the Dual Tower,
as shown below.
13. Attach Track 6 to Track 9,asshownbelow.

14
14
14
14. Attach the Track Sign to Track 8.Then, insert the Launcher
Supports into the Dual Tower.Finally,connectTrack 8 and Track
7to the Launcher Supports and Track 6,asshownbelow.
15. Attach Launcher 1 to Track 8 and connect Launcher 2 to Track
7,asshownbelow.

15
15
15
Onceyou’vecompletedtheabovesteps,youarereadytoplay!You
can connect the playset to other Go! Go! Smart Wheels®playsets and
tracks (each sold separately).
EXPAND & EXPLORE
Connect to the Go! Go! Smart Wheels®Save the Day Fire Station™
(as shown below) or other Go! Go! Smart Wheels®playsets (each
sold separately) to expand the Launch & Chase Police Tower™and
inspire creativity.

16
16
16
PRODUCT FEATURES
Police Car
1. ON/OFF SWITCH
To turn the unit ON, slide the On/Off
Switch to the ON ( ) position. To
turn the unit OFF,slide the On/Off
Switch to the OFF ( ) position.
2. AUTOMATIC SHUT-OFF
To preserve battery life, the included Police Car will automatically
power down after approximately 60 seconds without input.
The unit can be turned on again by pressing the Light-Up
Button, pushing quickly or triggering a SmartPoint®location.
Note: This product is in try-me mode in the packaging. After
opening the package, turn the vehicle off and on again
to proceed with normal play. If the unit powers down
while playing, we suggest changing the batteries.
ACTIVITIES
Police Car
1. Slide the On/Off Switch to turn the
Police Car ON.Youwillhearasong,
phrase and sounds. The light will
flash with the sounds.

17
17
17
2. Press the Light-Up Button to hear
sounds,songsandphrases.Thelight
will flash with sounds.
3. Push the Police Car to hear fun
sounds and melodies. While a
melody is playing, push the Police
Car again to add in fun sounds on
top of the melody. The light will flash
with the sounds.
4. For added fun, the Police Car
interacts with the Go! Go! Smart
Wheels®Launch & Chase Police
Tower™. Simply place the Police
Car on one of the five SmartPoint®
locations to see the Police Car’s
light flash and to hear fun sounds,
short tunes and phrases. The Police
Car even interacts with other Go!
Go! Smart Wheels®playsets (each
playset sold separately).

18
18
18
ACTIVITIES
Launch & Chase Police Tower™
1. Place the Police Car or any
SmartPoint®vehicle (each sold
separately) on the five SmartPoint®
locations to trigger fun sounds,
songs or phrases
2. Put the Police Car and Getaway Car
in the SmartPoint®launchers,liftthe
launchers and watch them race to
the bottom.
3. TrytoslowdowntheGetawayCarbyexposingthespeedbumps,
raising the barricades and moving the switch track.

19
19
19
SONGS
1. I’mtheGo!Go!Smartpolicecar,
 policecar,policecar,
 I’mtheGo!Go!Smartpolicecar,
Cruising ‘round the town
2. Timetoturnonthesiren,thesiren,thesiren,
 Timetoturnonthesiren,
We’re racing to the scene!
3. Gettothesceneandfollowclues,
To catch the bad guy and his crew!
MELODY LIST
1. Aiken Drum
2. A-Tisket,A-Tasket
3. Muffin Man
4. Where Has My Little Dog Gone
5. Turkey in the Straw
6. YankeeDoodle

20
20
20
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2.
Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
Ifforsomereasontheunitstopsworking,pleasefollowthesesteps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Lettheunitstandforafewminutes,thenreplacethebatteries.
4. Turn the unit ON. The unit should now be ready to play again.
5.. Iftheproductstilldoesnotwork,replacewithanentiresetofnew
batteries.
Iftheproblempersists,pleasecallourConsumerServicesDepartment
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, or by
going to our website at vtechkids.com and filling out our Contact Us
form located under the Customer Support link. A service representative
will be happy to help you.