V-tech nickelodeon PAW PATROL RESCUE DRIVER ATV & FIRE... User manual

Instruction Manual
RESCUE DRIVER ATV & FIRE TRUCK
TM & © 2023 VTech Holdings Limited. All rights reserved.
© 2023 Spin Master PAW Productions Inc. All Rights Reserved.
PAW Patrol and all related titles, logos and characters are
trademarks of Spin Master Ltd. Nickelodeon and all related
titles and logos are trademarks of Viacom International Inc.

2
INTRODUCTION
Thank you for purchasing the PAW Patrol Rescue Driver ATV & Fire
Truck! This interactive driver includes Ryder’s ATV and Marshall’s re
truck modes for exciting role-play.
Pup Buttons
Left Turn Signal
Off/Low/High
Volume Selector
Mode Selector
Left Handgrip
7 Blue LEDs
Steering Wheel
Right Turn Signal
Control Handle
Right Handgrip
Call Button
Emergency Signal Button
Horn Button
1
2
3
4
5
6 7
8
9
10
11 1312
1
6
2
3
4
5
7
13
8
9
11
12
10

3
INCLUDED IN THIS PACKAGE
• One PAW Patrol Rescue Driver ATV & Fire Truck
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of
this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d'utilisation car il comporte
des informations importantes.
Rotate the packaging locks 90
degrees counterclockwise.
Pull out the packaging locks and
discard.
Unlock the Packaging Locks

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to
be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in re.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On, turn the Off/Low/High
Volume Selector to Low or High
position.
To turn the unit Off, turn the Off/Low/
High Volume Selector to Off position.
2. Pup Buttons
Press the Pup Buttons to learn about
each pup, hear the music and help them
complete missions.
3. Mode Selector
Turn the Mode Selector to choose Music
mode, Learning mode or Mission mode.
4. Call Button
Press the Call Button to learn about the
Call Button, hear walkie talkie sounds or
answer the questions.

6
5. Horn Button
Press the Horn Button to learn about the
Horn Button, honk the horn or answer
the questions.
6. Emergency Signal Button
Press the Emergency Signal Button
to learn about the Emergency Signal
Button, turn the siren on or answer the
questions.
7. Left and Right Handgrips
Turn both Left and Right Handgrips out
to transform into Ryder’s ATV or turn both
Left and Right Handgrips in to transform
into Marshall’s re truck.
8. Steering Wheel
Turn the Steering Wheel to the left or
right to learn directions or answer the
questions.
9. Control Handle
Turn the Control Handle to different
positions to hear fun sounds, control the
melody or answer the questions.

7
10. Automatic Shut-Off
To preserve battery life, the unit will automatically power off after
several minutes with no input. The unit can be turned on again
by turning the Off/Low/High Volume Selector to Low Volume
or High Volume position, or by turning the Mode Selector to the
Music Mode, Learning Mode or Mission Mode position. If the
unit repeatedly powers down or the light ashes then fades out, we
suggest changing the batteries.
ACTIVITIES
1. Music Mode
Turn the Mode Selector to to enter
this mode. Turn the Control Handle to
green to play the melody, press the Pup
Buttons to choose a melody or hear fun
sounds. When a melody is playing, turn
the Control Handle to blue to speed up
the melody, or turn to red to turn off the melody. Turn both Handgrips
to transform between Ryder’s ATV and Marshall’s re truck. Turn
the Steering Wheel and press the Call Button, Horn Button and
Emergency Signal Button for driving fun.
2. Learning Mode
Turn the Mode Selector to to enter this
mode. Turn both Handgrips to transform
between Ryder’s ATV and Marshall’s re
truck. Press the Pup Buttons to hear
Ryder or Marshall introduce each pup.
Press the Call Button, Horn Button,
Emergency Signal Button, or turn
the Steering Wheel to learn about directions and more. Turn the
Control Handle to green or blue to turn on vehicle sounds. Turn to
red to turn off vehicle sounds.
3. Mission Mode
Turn the Mode Selector to to enter
this mode. Follow Ryder’s instructions to
complete the missions with the pups.

8
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow
these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and lling out
our Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions you might
have. A service representative will be happy to help you.

9
Note:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
CAN ICES-003(B)/NMB-003(B)
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5427
Product Name: PAW Patrol Rescue Driver ATV & Fire Truck
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200,
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.

Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
TM & © 2023 VTech Holdings Limited.
All rights reserved.
IM-542700-000
Version:0