V-tech Play & Go Puppy Salon Assembly Instructions

Parent’s Guide
Play & Go Puppy Salon

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
INTRODUCTION
Thank you for purchasing the Play & Go Puppy Salon.
Take this puppy carrier wherever you go, then open to reveal a pet
grooming salon! Lights and sound effects enrich playtime as you
pretend to wash, comb, dry and clip this soft pup. Learn about colours
and puppy grooming as you play!
Mode Selector
Light Up Buttons
Hair Dryer
Puppy
Shower Head
Swivel Seat
Shower Base
Shampoo Bottle
On/Off
Volume Selector

3
INCLUDED IN THIS PACKAGE
•Play & Go Puppy Salon
•Parent’s Guide
• 1 puppy • Puppy carrier/salon
•clippers
• 1 comb
• 1 towel • 1 bone

4
NOTE
This toy is not intended for teething.
The infrared light sensors in the grooming set are sensitive to
sunlight. The sensors may not perform properly in brightly lit, sunny
rooms or under direct sunlight.
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE
Please keep this Parent’s Guide as it contains important information.
Unlock the Packaging Locks
Rotate the packaging locks 90 degrees
anticlockwise.
Pull out the packaging locks and discard.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Find the battery cover located on
the back of the unit. Use a coin or
screwdriver to loosen the screw.
3. If used batteries are present,
remove these batteries from the
unit by pulling up on one end of
each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).

5
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

7
PRODUCT FEATURES
1. On/Off/Volume Selector
Slide the On/Off/Volume Selector
to the Low volume position or to
the High volume position. Slide the
selector to the Off position to turn the
unit off.
2. Mode Selector
Slide the Mode Selector to learn
about puppy grooming and more with
Learning, Grooming Fun and Sounds
& Music modes.
3. Light Up Buttons
Press the five Light Up Buttons to
learn about colours, grooming and
more.
4. Swivel Seat
Place Puppy on the Swivel Seat to
hear fun responses. Swivel the seat
to the left for the styling station .
Swivel the seat to the middle for the
grooming station . Swivel the
seat to the right for the wash station
.

8
5. Hair Dryer
Pick up the Hair Dryer from the slot
or put it back in the slot to hear fun
sounds.
6. Shampoo Bottle
Press the Shampoo Bottle to learn
about counting and hear fun sounds.
7. Shower Base
Press the Shower Base to hear fun
sounds.
8. Automatic Shut-Off
To preserve battery life, the Play & Go Puppy Salon will
automatically shut off after several minutes without input. The unit
can be turned on again by sliding the On/Off Volume Selector
to the Low or High volume position, or by sliding the Mode
Selector to another mode.
NOTE:
If the unit powers down or if the lights fade during play, please
install a new set of batteries.

9
ACTIVITIES
1. Learning Mode
Press the five Light Up Buttons to
learn about colours, grooming and
more. Place Puppy on the Swivel
Seat and swivel the seat to any
location to hear fun phrases. Use the
Hair Dryer, Shampoo Bottle and
Shower to trigger phrases and lights.
2. Grooming Fun Mode
Press the five Light Up Buttons,
Shampoo Bottle, Shower Base or
remove the Hair Dryer from the slot
to guide you through puppy grooming
as you play. Place Puppy on the seat,
then swivel the seat to any location to
hear fun phrases.
3. Sounds & Music Mode
Press the five Light Up Buttons to
hear melodies. Press the buttons
again during the melodies to add fun
sounds. Press the Shampoo Bottle,
Shower Base or Hair Dryer to hear
fun sounds. Place Puppy on the seat
to hear Puppy sing a song or sing
together with the melodies. Swivel the
seat to trigger fun sounds with lights.