V-tech MY FIRST KidiSmartwatch User manual

MY FIRST
Instruction Manual

3
INTRODUCTION
Thank you for purchasing My First KidiSmartwatch!
This digital puppy can help children keep track of all their daily
routines. Create repeating reminders for potty training, nap time, meals
and more with this smart, interactive watch. Give the pup a name, then
feed, walk and groom them using the touch screen. Time-telling tools
are also included to help children learn how to tell the time.
Touch Screen Micro-USB Port
Clock Button
Microphone
Ring Light
Master Power Switch
Home Button
Wristband

4
INCLUDED IN THE PACKAGE
• My First KidiSmartwatch
• Micro-USB cable
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of
this toy and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
This toy is only to be connected to equipment bearing either of the
following symbols: or
The label covering the LCD screen of the product is packing material,
please remove this label before use.
Rotate the packaging lock
anticlockwise several times.
Pull out the packaging lock and discard.
Removing the Packaging Locks
WARNING
Adult needed to remove small packaging screw.

5
PRODUCT SPECIFICATION
Display Colour touch screen
Micro-USB Micro-USB 2.0 cable (included) for
battery charging
Connectivity (Unit to Unit)
Connect to another My First
KidiSmartwatch to play games and
send emoticons (best communication
range within 16ft or 5m)
Battery Li-ion battery (not replaceable)
Optimum Operating and
Charging Temperature 32°F - 104°F (0°C - 40°C)
WARNING
People with very sensitive skin may notice some irritation after wearing
the My First KidiSmartwatch for extended periods of time. The skin
may become irritated when moisture, sweat, soap, or other irritants
get trapped under the wristband and are left in contact with the skin.
To prevent this, we suggest children remove the watch before going
to bed for the night, take the watch off if it’s feeling uncomfortable, and
keep their wrist and the band clean and dry.
In addition, wearing the watch too tightly may also cause irritation.
Make sure the t is good - tight enough so the watch stays in place but
not so tight that it’s uncomfortable. If you notice any redness, swelling,
or other irritation, you may want to consult a doctor before wearing the
watch again.
GETTING STARTED
Master Power Switch
When you use My First KidiSmartwatch for the
rst time, you will need to slide the Master Power
Switch (located on the underside of the watch)
to the On position (-). You may need a small tool
such as a paper clip to move the switch to the On
position. Fully charge the watch before rst use.
When the Master Power Switch is set to the Off

6
position (o), the unit will not function and the battery will not charge.
Only move the switch to the Off position when the watch will not be
used for an extended period of time.
Note: It is not necessary to turn the watch off in daily use. Once the
Master Power Switch is Off, the watch will stop functioning. After it is
turned On again, the time and date will have to be reset.
BATTERY RECHARGING
Note: Adult operation required.
The watch should be fully charged before rst use. To charge the
My First KidiSmartwatch, connect the watch to a computer using
the included Micro-USB Cable (Please refer to the CHARGING
GUIDELINES section of this guide). To do so correctly, please follow
these steps:
• Make sure that the Master Power Switch is set to the On position
before charging.
• Pull open the rubber cover of the Micro-USB Port on the side of the
watch.
• Insert the Micro-USB Cable (small end) into the Micro-USB Port on
the watch.
• Insert the large end of the Micro-USB Cable into a USB port on your
computer or USB port (Output DC 5V 1A) with Class II or III
symbol.
• Once the connection is successful, you will see a battery charging
symbol appear on the watch screen.
• Check the charging progress regularly throughout recharging.
• When the battery is fully charged, the fully
charged battery icon will appear. Then the
screen will automatically turn off. You may then
disconnect your fully charged watch from the
computer.
Note: It will take approximately 3.5 hours to fully
charge the battery. The actual charging time
depends on the charging current, the remaining charge in the battery
prior to recharging, and the ambient temperature. The optimum
ambient temperature is
32°F - 104°F (0°C to 40°C).

7
CHARGING GUIDELINES
To charge the My First KidiSmartwatch, use only the included Micro-
USB Cable to connect to a computer or other equipment with a USB
port (Output DC 5V 1A) and bearing the following Class II or III
symbol. Do not charge using a third party adaptor. Before use, inspect
the cable to conrm that it is in good condition and that there are no
breaks or exposed wires. Ensure there are no particles or liquid (water,
juice, etc.) in either of the connectors before plugging in either end of
the cable. The device should be completely dry with no debris in the
cable connectors when charging. Plug in the cable securely, in the
correct orientation. Never leave the device unattended while charging.
Do not charge your device on soft surfaces, as they can trap heat
around the device. Typical charging time is approximately 3.5 hours
if the battery is fully depleted. Disconnect the device when it is fully
charged. Do not leave the device charging for more than four hours.
Examine the charging cord periodically for conditions that may result
in the risk of re, electric shock, or injury to persons such as damage
to the cord, housing, or other parts. In the event of such conditions, the
cord should not be used until properly repaired or replaced.
BATTERY LIFE
The time the battery lasts between charges depends on play. Like
other electronic devices, more frequent usage will drain the battery
more quickly. The remaining battery capacity will appear in the top
right corner of the screen. When the battery level is low, recharge the
battery before further use. When the battery level is too low, the watch
will not turn on until it is recharged.
If you nd the time between charges is considerably shortened with
no change in usage, the battery could be nearing the end of its life.
The battery life varies from battery to battery depending on storage,
operating conditions and environment.
BATTERY TIME FOR REFERENCE
Condition Battery Time
Low Usage 2 weeks
Typical Usage 2 days
Heavy Usage 1 day
Note: The above battery time assumptions are based on the screen
display set to turn off when not in use. Please see the Settings section
for more details about this option.

8
BATTERY MAINTENANCE
Charge the battery regularly to keep it operating at optimum
performance, even when the watch isn’t in regular use. For example,
charge the watch at least once every six months. Slide the Master
Power Switch to the Off position if the watch will not be in use for an
extended period of time.
This toy contains batteries that are non-replaceable.
Australia/New Zealand
WARNING! SAFETY INSTRUCTIONS, PLEASE READ
THOROUGHLY BEFORE GIVING THIS PRODUCT TO A CHILD.
KEEP AWAY FROM FIRE OR HEAT SOURCE.
BATTERIES CANNOT BE REPLACED.
The batteries within this toy are permanently encased. Before giving
this toy to a child make sure there are no signs of damage. Regularly
check the toy and dispose of it immediately if there are any signs of
damage. Do not dispose of the toy in a re, as the batteries may leak
and explode. Keep batteries safely out of children’s reach before
disposing of them via a safe disposal system.
The battery in this product must not be disposed of with household
waste. This battery is recyclable. Please follow your local recycling
regulations.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in the
Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product or
batteries responsibly.

9
VTech®cares for the planet.
Care for the environment and give your toy a second life by disposing
of it at a small electricals collection point so all its materials can be
recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.
WARNING MESSAGES
1
Master Power Switch Is Off
Slide the Master Power Switch to the On
position (-) before charging the battery.
2
Temperature Out of Range
The charging temperature range should be
32°F - 104°F (0°C - 40°C).
SPLASH-PROOF FOR EVERYDAY PLAY
• Do not put under running water.
• Do not submerge in water. Not suitable for showering, bathing or
swimming.
• Keep the rubber cover over the Micro-USB Port closed tightly while
it is not in use in order to prevent water damage.

10
QUICK GUIDE ABOUT ALARM AND
ALERT SOUNDS
My First KidiSmartwatch can help to remind children of good habits.
The following table indicates the different alarms and reminders
available on the watch.
Alarm To turn the alarm On or Off, go to the Home
Menu and swipe left or right to nd the Alarm
icon. Tap the Alarm Clock icon to set the alarm.
Tap the Bell icon to turn the alarm On or Off. Tap
the displayed time to set it.
Reminder To set the reminder, go to the Home Menu and
swipe to see the Reminder icon. If there are
reminders set, tap to see all the reminders. Tap
the icon to set to On, Off or Repeat.
Woof Woof
Clock
If the Woof Woof Clock feature is set to On, the
watch will make a "woof woof" sound at the top
of every hour from 7:00 a.m. to 7:00 p.m. To turn
this feature on or off, swipe left or right on the
Home Menu screen to nd the Woof Woof Clock
icon. Tap the Woof Woof Clock icon. Tap the Set
icon and select On or Off.