V-tech Ride & Go Recycling Truck Assembly Instructions

Parent’s Guide
Ride & Go Recycling Truck

2
2
2
INTRODUCTION
Thank you for purchasing the Ride & Go Recycling Truck! Take a
ride and learn about recycling and the environment! Pick up blocks
and sort them by shape and colour, then store them inside the truck.
6 Blocks
Ignition Key
Horn Button
Truck Scoop
Off/Low/High
Volume
Mode Switch
3 Lights
3 Smart
Sorting Bins
12 Recycling Buttons

3
3
3
INCLUDED IN THE PACKAGE
• Ride & Go Recycling Truck
• Label sheet
• Parent’s Guide
• 6 Blocks

4
4
4
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws
are not part of this toy and should be discarded for your child’s
safety.
NOTE
Please keep this parent’s guide as it contains important
information.
Removing the Packaging Locks:
Rotate the packaging lock anticlockwise 90
degrees.
Pull out the packaging lock.
WARNING!
Not to be used by children over 36 months. Insufficient strength.
20kg Max. Regularly check for signs of wear or tear on the snap in
or locking devices. If damaged do not use until repaired or replaced.
Only to be used under the direct supervision of a competent adult.
• This toy should be used in a safe area e.g indoors, in a private
garden, on level flat surfaces and away from any hazards such
as cars, stairs, water etc.
• Not for use on pavements or in traffic.
• Adult supervision is advised.
• Please help your child to sit properly on the seat and to use the
toy correctly.
• Since skill is required this toy should be used with caution to
avoid falls or collisions that could cause injury to the user or third
parties.

5
5
5
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located under
the Mode Switch. Use a screwdriver
to loosen the screw and open the
battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.

6
6
6
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on
the market after 13th August, 2005.
Help protect the environment by disposing of your
product or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by disposing
of it at a small electricals collection point so all its materials can be
recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

7
7
7
LABEL APPLICATION
Please securely stick the labels to the toy as indicated below:
PRODUCT FEATURES
1. Truck Scoop
Move the Truck Scoop up and down to drop blocks into the
truck and play fun sound effects.
2. Ignition Key
Turn the Ignition Key to hear engine
sounds.

8
8
8
3.Horn Button
Press the Horn Button to hear horn
sound effects.
4.Recycling Buttons
Press the Recycling Buttons to learn
how to help the environment and how
to sort objects by plastic, glass and
paper.
5.Mode Switch
Slide the Mode Switch to explore
recycling game modes through music,
quizzes and more!
6. Off/Low/High Volume
Slide the Off/Low/High Volume switch
to the Low or High volume position
to turn the unit on and adjust volume.
Slide the switch to the Off position to
turn off the unit.

9
9
9
7. 3 Smart Sorting Bins
Insert a block into a Smart Sorting Bin
to learn colours and shapes.
8. 3 Lights
The 3 lights will light up according to
the game play.
9. Storage
Scoop and sort the blocks by shape
and colour, then store them in the truck.
10. Automatic Shut-Off
To preserve battery life, the Ride & Go Recycling Truck will
automatically shut off after several minutes without input. The unit
can be turned on again by sliding the Mode Switch.
The unit will also automatically turn off when the batteries are
very low.
NOTE
If the unit powers down or if the lights fade during play, please install a
new set of batteries.