V-tech Toot Toot Drivers Assembly Instructions

Parent’s Guide
Launch & Spin Raceway
91-003714-001

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
2
2
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Drivers®Launch
& Spin Raceway!
Get ready to flip, jump and spin with the Toot-Toot Drivers®Launch
& Spin Raceway. This interactive raceway features two levels of
pretend play and learning fun! Place the Race Car on the second
level platform, choose the launch ramp or the bumpy off road ramp
and raise the gate to send it sliding down to the roundabout for
whirling, twirling fun. Place the Race Car on the repair lift to launch
him back onto the roundabout. Then, turn the handle to spin the
roundabout sending the Race Car on a dizzy ride!
SmartPoint®
Race Car
Repair Lift Roundabout

3
3
3
INCLUDED IN THIS PACKAGE
One gallery
One SmartPoint®
Race Car
One racing platform
Gate BGate A Two platform
supports
One road block One jump track
One sign post,
One flip up sign
One repair deck
NOTE: This toy is not intended for teething.
One handle
One bumpy track
One lever

4
4
4
One label sheet
One base supportOne base
One adaptor
Three screws
One Parent’s Guide

5
5
5
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy and should be discarded for your child’s safety.
NOTE: Please keep the Parent’s Guide as it contains important
information.
Adult assembly required.
Unlock the packaging locks:
Turn the packaging lock anticlockwise
several times.
Pull out and discard the packaging lock.
GETTING STARTED
BATTERY INSTALLATION
Race Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the Race Car. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance).
4. Replace the battery cover and tighten
the screw to secure.

6
6
6
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.

7
7
7
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
ThechemicalsymbolsHg,CdorPb,wheremarked,
indicate that the battery contains more than the specified
valueofmercury(Hg),cadmium(Cd)orlead(Pb)set
outinBatteryDirective(2006/66/EC).
The solid bar indicates that the product was placed on
the market after 13th August, 2005.
Helpprotecttheenvironmentbydisposingofyour
product or batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com

8
8
8
1
2
7
6
4
5
LABEL APPLICATION
Please stick the labels to the play set securely as
indicated on the following pages:

9
9
9
812
13 18
10
22 21
11
14
16
15
17
20
9