V-tech Rock & Ride Unicorn Assembly Instructions

Rock & Ride Unicorn
91-003259-024
Parent’s Guide

3
2 LIGHT UP
BUTTONS
2 HANDLES
TURNING DISC
ON/OFF/MODE
SWITCH
VOLUME
CONTROL
SWITCH
INTRODUCTION
Thank you for purchasing the VTech®Rock & Ride Unicorn.
The Rock & Ride Unicorn easily transforms from a rocker to a
ride-on. The two chunky handles are easy for toddlers to grasp
when riding on the Unicorn. Press one of the two light up buttons to
learn about colours and to hear playful songs & imaginative phrases.
Rocking or riding on the Unicorn triggers the motion sensor which
responds with fun melodies and sounds.

4
INCLUDED IN THIS PACKAGE
- One parent’s guide
- One sheet of labels
Two rockers One front link bracket
Two handles One back link bracket
Two plastic screws8 small screws
One Rock & Ride Unicorn Four wheels

5
WARNING: All packing materials such as tape, plastic sheets,
packaging locks, removable tags, cable ties and
packaging screws are not part of this toy and
should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains
important information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw.
3. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance).
4. Replace the battery cover and
tighten the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride)rechargeablebatteriesforbestperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.

6
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com

7
WARNING!
With the VTech®Rock & Ride Unicorn safety comes first:
Adult assembly required. Protective equipment should be worn
whilst riding on the Unicorn. Please wear a helmet, gloves, knee
pads and elbow pads. This toy should not be used near traffic
or on pathways. The maximum weight limit is 20kg. Children
over this weight should not use the ride on. Not to be used by
children over 36 months. Insufficient strength. This product
includes electronics and is not waterproof.
This package contains 8 small screws. For your child’s safety, do not
let your child play with the toy until it is fully assembled.
• Thistoyshouldbeusedinasafeareae.g.indoors,ina
private garden, on level flat surfaces and away from any
hazards such as cars, stairs, water etc.
• Notforuseonpavementsorneartraffic.
• Adultsupervisionisadvised.
• Regularlycheckifthe8screwsaresecurelytightenedtolink
the brackets and rockers.
Please stick the labels to the Unicorn securely as
indicted below:

8
ASSEMBLY INSTRUCTIONS
1. Insert the 4 wheels into the two
rockers as shown. You will hear the
wheels click into place to indicate
they are attached securely.
2. Insert the front link bracket and the back link bracket onto the
inside of the rockers. Secure the brackets to the rockers with the
small screws provided.
3. Insert the Rock & Ride Unicorn onto
the support brackets as shown.
4. Insert the two plastic screws into the
holes in the front link and back link
brackets. Turn the screws clockwise
to secure. You will hear the locks
click into place to indicate they are
attached securely.

9
5. Insert the two handles into the side of
the Unicorn’s head. You will hear the
handles click into place to indicate
the handles are attached securely.
TRANSFORM FROM ROCKER TO RIDE-ON MODE
6. To change the Unicorn from rocker mode to ride-on mode, press
and hold the lock next to the plastic screws and turn the screws
anticlockwise. Remove the rocker panel and turn it over so the
wheels are on the ground. Re-insert the two plastic screws into
the holes in the front link and back link brackets. Turn the screws
clockwise to secure.
PRODUCT FEATURES
1. ON/OFF/MODE SWITCH
To turn the unit ON, slide the
ON/OFF/MODE SWITCH to the
LEARNING & MUSIC MODE or
the ADVENTURE MODE position.
To turn the unit OFF, slide the ON/
OFF/MODE SWITCH to the OFF ( )
position.

10
2. VOLUME CONTROL SWITCH
To adjust the volume, slide the
VOLUME CONTROL SWITCH to
the LOW VOLUME ( ) or the HIGH
VOLUME ( ) position.
3. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech®Rock & Ride Unicorn will
automatically shut-off after approximately 65 seconds without
input. The unit can be turned on again by pressing any button, or
by turning the disc.
Note: If the unit repeatedly shuts off quickly, we suggest changing
the batteries.
ACTIVITIES
1. Slide the ON/OFF/MODE SWITCH
to turn the unit on. You will hear a
playful song and a friendly phrase.
The lights will flash with the sounds.
2. Press the LIGHT UP BUTTONS to
learn about colours and to hear fun
songs & music in Learning & Music
Mode. In Adventure Mode you will
hear playful phrases, sounds and
songs. When a melody is playing,
press the LIGHT UP BUTTONS to
play the melody one note at a time.
The lights and horn will flash with the
sounds.