V-tech Switch & Go Dinos - Akuna The Velociraptor... User manual

User’s Manual
© 2013 VTech
Printed in China
91-002813-001 UK
Akuna the Velociraptor
®

2
INTRODUCTION
I’m Akuna the Velociraptor! I may be small for a meat-eating dino,
but I’m clever and quick and often hunt with my friends. The sharp
and deadly claws on my feet will make anyone think twice about
challenge me!
When I’m a dino I’m a stealthy and clever hunter, and when I change
in to a bike I can run rings around any of my foes!
Introduction
Sound Button
Light-up
Eyes
Talk Button
On/Off Switch &
Volume Control

3
INCLUDED IN THIS PACKAGE
• OneVTech®SWITCH & GO DINOS®:Akuna the Velociraptor
• Oneuser’smanual
WARNING: All packing materials, such as tape, plastic sheets,
packaging locks and tags are not part of this toy, and
should be discarded for your child’s safety.
NOTE: Please keep instruction manual as it contains important
information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a screwdriver
to loosen the screw.
3. Install 1 new AA (LR6/AM-3) battery
into the main unit following the
diagram inside the battery box.
(The use of new, alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and
tighten the screw to secure.
Note:
If there is no response when the unit is switched on, please insert
a new battery and try switching it on again.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
Getting Started

4
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinre.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specied value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive(2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product or
batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com
Battery Notice

5
PRODUCT FEATURES
1. ON/OFF SWITCH & VOLUME CONTROL
This product has a single switch that
turns the unit ON or OFF and controls the
volume.
To turn the unit ON or adjust the volume,
slide the switch to Low /High .
To turn the unit OFF, slide the switch to
OFF .
2. TALK BUTTON
Press the Talk Button to hear the dino
or driver talk.
3. SOUND BUTTON
Press the Sound Button to hear cool
sound effects.
4. AUTOMATIC SHUT-OFF
To preserve battery life, the unit will automatically power-off after
several minutes without input.
Product Features

1.Dinosaurshape. 2. Rotate the body all the way
back until it meets the tail.
3. Move the head forward as
far as it will go.
4. Turn the back wheel 90
degrees.
6. Flip the legs up.5. Pull down the kickstands
so that the motorcycle can
stand up. 6
HOW TO SWITCH THE DINO TO A MOTORCYCLE
How to Switch

7. Move the tail pipes down. 8. Motorcycle shape.
Note:
To change the motorcycle back into a dino, reverse the order of the
steps above.
7
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit is not in use for an extended
period of time.
4.Donotdroptheunitonhardsurfacesanddonotexposetheunitto
moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with a new set of batteries.
Care & Maintenance / Troubleshooting

8
Troubleshooting
Iftheproblempersists,pleasecallourConsumerServicesDepartment
on 01235 546810 (from UK) or [phone] (outside UK) and a
service representative will be happy to help you.
IMPORTANT NOTE:
Creating and developing VTech®products is accompanied by
a responsibility that we at take very seriously. We make every
effort to ensure the accuracy of the information which forms the
value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products
andencourageyoutocallourConsumerServicesDepartment
on 01235 546810 (from UK) or [phone] (outside UK)
with any problems and/or suggestions that you might have. A
service representative will be happy to help you.