V-tech Switch & Go Spinosaurus Race Car Assembly Instructions

Parent’s Guide
US
91-003515-005 CA
Spinosaurus Race Car

2
INTRODUCTION
Thank you for purchasing the Switch & GoTM Spinosaurus Race Car!
Engage your imagination with this speedy race car that transforms into
a super cool spinosaurus. Fun sounds and phrases bring the action to
life in your very own dinosaur universe.
Talk Button Sound Effect Button
On/Off/Volume Selector
LED Lights

3
INCLUDED IN THIS PACKAGE
• Switch & Go™Spinosaurus Race Car
• Parent’s guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE
Please keep this parent’s guide as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw
and open the battery cover.
3. Remove the old battery by pulling
up on one end of it.
4. Install 1 new AAA (LR03/AM-4)
battery following the diagram
inside the battery box.
5. Replace the battery cover and
tighten the screw to secure.

4
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity (+ and -).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Donotdisposeofbatteriesinre.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
MISE EN GARDE
Les piles fournies avec le produit permettent de tester le jouet en
magasin mais ne sont pas des piles longue durée.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mélanger différents types de piles ou d’accumulateurs, ne pas
mélanger des piles ou des accumulateurs neufs avec des usagés.
• Ne pas utiliser des piles ou des accumulateurs endommagés.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et - .
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en court-
circuit (en reliant directement le + et le -) .
• Enlever les piles ou les accumulateurs usagés du jouet.
• Retirer les piles ou les accumulateurs en cas de nonutilisation
prolongée.
• Ne les jeter ni au feu ni dans la nature.
• Ne pas tenter de recharger des piles non rechargeables.
• Enlever les accumulateurs du jouet pour les recharger.
• Les accumulateurs ne doivent être chargés que sous la surveillance
d’un adulte.

5
PRODUCT FEATURES
1. On/Off/Volume Selector
To turn the unit On or adjust the volume,
slide the switch to Low or High .
To turn the unit Off, slide the switch to
Off .
2. Talk Button
Press the Talk Button to hear fun
phrases from the dino or driver.
3. Sound Effect Button
Press the Sound Effect Button to hear
cool sound effects.
4. Automatic Shut-Off
To preserve battery life, the unit will automatically shut off after
approximately 20 seconds without input. The unit can be turned
on again by pressing any button.

6
1. Begin in Vehicle mode. 2. Flip the legs down.
3. Unfold the tail. 4. Rotate the claws down.
5.Finish in Dino mode.
TRANSFORMATION
NOTE
To switch the dino back into a vehicle, follow the above steps in
reverse order.

7
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow
these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697
in Canada, or visit our website vtechkids.com and ll out our
Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions you might
have. A service representative will be happy to help you.

8
CAUTION
Changesormodicationsnotexpresslyapprovedbytheparty
responsible for compliance could void the user’s authority to operate
the equipment.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

9
Supplier’s Declaration of Conformity
Trade Name: VTech®
Model: 5208
Product Name: Switch & GoTM Spinosaurus Race Car
Responsible Party: VTech Electronics North America, LLC
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)

Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
Read our complete warranty policy online at
vtechkids.com/warranty
TM & © 2018 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-003515-005 US CA