V-tech Switch & Go Velociraptor Jet User manual

VELOCIRAPTOR JET
Instruction Manual
®
US
91-004023-000 CA

2
INTRODUCTION
Switch into fun with the Switch & Go®Velociraptor Jet. Transform
this cool Jet into a ferocious Velociraptor and back in just a few
simple steps. Launching propellers, flame effects and an animated
LCD screen bring the action to life in your very own dino universe.
Off/Low/High
Volume Switch
Projection
Light Button
Voice
Button
Propeller
Launcher
LCD
Screen
NOTE
Do not aim propellers at face or eyes.

3
INCLUDED IN THE PACKAGE
• Switch & Go®Velociraptor Jet
• 2 Propeller Discs
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not
part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel car il comporte des
informations importantes.

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw,
then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

6
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
Les piles fournies avec le produit permettent de tester le jouet en
magasin mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-
carbone et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.
PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On or adjust the volume,
slide the switch to the Low or High
volume position. To turn the unit Off, slide
the switch to the Off position.

7
2. Projection Light Button
Press the Projection Light Button
and the unit will project a light pattern.
3. Voice Button
Press the Voice Button to hear fun
phrases and cool sounds.
4. Propeller Launcher
Spin the propeller disc clockwise
several times, and then press the
Propeller Launcher. The propeller
disc will fly out.
Note: Do not aim at eyes or face.
5. LCD Screen
The LCD Screen shows dino eye
animations in Dino mode and
shows pilot animations in Jet mode.
6. Automatic Shut-Off
To preserve battery life, the unit will automatically shut off after
approximately 20 seconds without input. The unit can be turned
on again by pressing the Voice Button or Projection Light
Button or by switching between Dino and Jet modes. The unit
will also automatically turn off when battery power is very low.

4. Move the Dino’s head down.
1. Begin in Jet mode. 2. Flip out the Dino’s feet.
3. Flip down the Dino’s legs.
5. Flip down the Dino’s arms. 6. Flip up the Dino’s tail. The
unit is now in Dino mode.
8
TRANSFORMATION
NOTE
To switch the Dino back into a Jet, follow the above steps in reverse order.

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697
in Canada, or visit our website vtechkids.com andll outour
Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort
to ensure the accuracy of the information, which forms the value
of our products. However, errors sometimes can occur. It is
important for you to know that we stand behind our products
and encourage you to contact us with any problems and/or
suggestions you might have. A service representative will be
happy to help you.

10
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.