V-tech Switch&Go DINOS User manual

User’s Manual
© 2012 VTech
Printed in China
91-002765-001
UK
Span the Spinosaurus

Introduction
2
INTRODUCTION
I’m Span the Spinosaurus, and I’m the biggest carnivore of all time.
My huge size, long jaws and sharp teeth make me a meat-eating machine.
And if that doesn’t scare you, the spines on my back will!
As a dinosaur I rule the land and water, as a plane I rule the skies. I can
turn into a super-fast jet fighter and fly faster than the speed of sound!
Talk Button
Launchers
Sound Button
Volume Button Style Button
LCD Screen
Tail Button
ON/OFF Switch

INCLUDED IN THIS PACKAGE
• One VTech®SWITCH & GO DINOS®:Span the Spinosaurus
• One user’s manual
WARNING:
All packing materials, such as tape, plastic sheets, packaging
locks and tags are not part of this toy, and should be discarded
for your child’s safety.
NOTE:
Please keep the user’s manual as it contains important
information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on
the bottom of the unit. Use a
screwdriver to loosen the screw.
3. Install 2 new AA (LR6/AM-3)
batteries into the main unit following
the diagram inside the battery box.
(The use of new, alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and
tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended. 3
Getting Started

• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com 4
Battery Notice

PRODUCT FEATURES
1. TURNING THE UNIT ON
Slide the ON/OFF Switch to ON to turn the unit ON.
2. MOTION SENSOR
Move the plane to hear awesome flying
sounds.
3. STYLE BUTTON
Press the Style Button to choose a pilot or
change the dino eyes.
4. TALK BUTTON
Press the Talk Button to hear the dino or pilot
talk.
5. SOUND BUTTON
Press the Sound Button to hear great
sound effects.
6. VOLUME BUTTON
Press the Volume Button to adjust the
volume.
7. TAIL BUTTON
Press the Tail Button to make the dino
chomp and roar.
5
Product Features

8. DISCS
Load the Discs into the launchers and press
the buttons to watch them fly.
9. LAUNCHERS
Press the Launchers to launch the discs.
10. DINO CAGE AND BABY DINO
Press the button to open the Dino Cage and
free the Baby Dino.
11. RESCUE LIFT
Use the Rescue Lift to carry the cage and
other Switch & Go Dinos too.
12. REATTACHING THE DINO JAW
If the lower jaw falls off, please follow the
steps below to reattach it.
1) Turn the Dino upside down and insert the
cylinder on the side of the jaw into the hole
on the underside of the head.
2) Fit the holes on each side of the jaw over the blue protrusions
located under the head.
13. TURNING THE UNIT OFF/ AUTOMATIC SHUT-OFF
Slide the ON/OFF Switch to OFF or hold the Talk Button / Sound
Button for a few seconds to turn the unit OFF.
To preserve battery life, the unit will automatically power-off after
several minutes without input.
6
Product Features
3
2
1

How to Switch
7
HOW TO SWITCH THE PLANE TO A DINO
2. Move the landing gear on the
bottom of the plane back.
1. Plane shape.
3. Move the sides of the tail in. Then
move the whole tail down.
4. Rotate the nose of the plane
down.
5. Pull the head out. 6. Rotate each of the wings
180 degrees so that they’re
facing backwards.

Care & Maintenance / Troubleshooting
8
Note: To change the dino back into a plane, reverse the order of the
steps above.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit is not in use for an extended
period of time.
4. Do not drop the unit on a hard surface and do not expose the unit
to moisture or water.
1:1
8. Move the spine up.7. Flip each of the wings down and
pull the feet down.

9
Note
IMPORTANT NOTE:
Creating and developing VTech®products is accompanied by
a responsibility that we at take very seriously. We make every
effort to ensure the accuracy of the information which forms the
value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products
and encourage you to call our Consumer Services Department
on 01235 546810 (from UK) or [phone] (outside UK)
with any problems and/or suggestions that you might have. A
service representative will be happy to help you.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with a new set of batteries.
If the problem persists, please call our Consumer Services Department
on 01235 546810 (from UK) or [phone] (outside UK) and a
service representative will be happy to help you.