V-tech SWITCH&GO VELOCIRAPTOR RACE CAR User manual

Instruction Manual
US CA
91-004006-000
VELOCIRAPTOR RACE CAR
All manuals and user guides at all-guides.com

2
INTRODUCTION
Switch into fun with the Switch & Go®Velociraptor Race Car.
Transform this ferocious Velociraptor into a powerful Race Car and
back in just a few simple steps. 30+ sounds and phrases bring the
action to life in your very own dino universe.
Off/Low/High Volume Selector
Head Button
LED Light
LCD Screen
All manuals and user guides at all-guides.com

3
INCLUDED IN THE PACKAGE
• Switch & Go®Velociraptor Race Car
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel car il comporte des
informations importantes.
All manuals and user guides at all-guides.com

4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit and use
a screwdriver to loosen the screw, then open the battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA size (AM-3/LR6)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
All manuals and user guides at all-guides.com

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
•
Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
All manuals and user guides at all-guides.com

6
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
Les piles fournies avec le produit permettent de tester le jouet en
magasin mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-carbone
et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.
All manuals and user guides at all-guides.com

7
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On or to adjust the volume,
slide the selector to the Low or High
Volume position. To turn the unit Off, slide
the selector to the Off position.
2. Head Button
Press the Head Button to hear fun phrases
and cool dinosaur sounds in Dino mode. In
Vehicle mode, press the Head Button to hear
fun phrases and great vehicle sounds. The
light projection will show with the response.
3. LCD Screen
The LCD Screen shows dino eye animations
in Dino mode and shows driver animations in
Vehicle mode.
4. LED Lights
The LED Lights flash along with the sounds in
Dino mode and Vehicle mode.
5. Automatic Shut-off
To preserve battery life, the unit will automatically shut off after
approximately 20 seconds without input. The unit can be turned
on again by pressing the Head Button or by switching between
Dino and Vehicle modes. The unit will also automatically turn off
when battery power is very low.
All manuals and user guides at all-guides.com

8
2. Push the legs up and
toward the body.
1. Dino mode.
3. Rotate the feet toward
the tail.
4. Push the arms up. The unit
is now in Vehicle mode.
TRANSFORMATION
NOTE
To switch the vehicle back into a dinosaur, follow the above steps in
reverse order.
All manuals and user guides at all-guides.com

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, install a new set of batteries.
All manuals and user guides at all-guides.com

10
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling
out our Contact Us form located under the Customer Support
link. Creating and developing VTech products is accompanied
by a responsibility that we take very seriously. We make every
effort to ensure the accuracy of the information, which forms the
value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products
and encourage you to contact us with any problems and/or
suggestions you might have. A service representative will be
happy to help you.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
All manuals and user guides at all-guides.com