V-tech Walk & Woof Puppy User manual

Instruction Manual
Walk & Woof Puppy

On/Off/Volume
Switch
Cord Storage Pull Cord
INTRODUCTION
Thank you for purchasing the Walk & Woof Puppy toy!
This playful interactive puppy loves to follow you around. Pull the
puppy along or press the buttons to hear letters, parts of the body,
and to listen to music.
Learning
Buttons
Twisting Tail Head
3
3
3

INCLUDED IN THE PACKAGE
• Walk & Woof Puppy
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important
information.
Unlock the Packaging Locks
Rotate the packaging lock 90 degrees
anticlockwise.
1
2Pull out the packaging locks and discard.
4
4
4

GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover on the bottom of
the unit, use a screwdriver to loosen the
screw, and then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
5
5
5

RECHARGEABLE BATTERIES:
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Please dispose of your product and batteries responsibly.
In the UK, give this toy a second life by disposing of it at a small
electricals collection point* so all of its materials can be recycled.
Learn more at:
www.vtech.co.uk/recycle
www.vtech.com.au/sustainability
* Visit www.recyclenow.com to see a list of collection points near you.
6
6
6

PRODUCT FEATURES
1. On/Off/Volume Switch
To turn the unit On, slide the On/Off/
Volume Switch to the Low volume
or High volume position. You
will hear a sound, phrases and a
song. To turn the unit Off, slide the
On/Off/Volume Switch to the Off
position.
2. Pull Cord Storage
To change puppy from a pull toy to
a push toy, store the pull cord by
opening the battery compartment
and tucking the cord inside. To use
as a pull toy again, open the battery
compartment and extend the cord.
Lay the cord in the notch and close
the battery compartment. For your child’s safety, we suggest you
store the pull cord in the compartment until your child is walking
and to supervise your child when playing with the pull cord.
3. Automatic Shut-Off
To preserve battery life, the Walk & Woof Puppy will
automatically shut off after approximately 65 seconds without
input. The puppy can be turned on again by pressing any button.
NOTE
If the unit powers down or if the light fades out during play, please
install a new set of batteries.
7
7
7

ACTIVITIES
1. Learning Buttons
Press the Learning Buttons to learn
letters, puppy facts and songs, you
will also hear melodies and sounds.
The light will flash with the sounds.
2. Pat the Puppy
Press the puppy’s Head to hear cute
sounds and phrases. The light will
flash with the sounds, and the ears
will move up and down.
3. Pull Along
Pull the puppy to hear fun sounds
and phrases to encourage play. The
light will flash with the sounds.
4. Twisting Tail
Twist the tail for manipulative fun!
8
8
8

MELODIES
1. While Strolling Through the Park
2. The Green Grass Grew All Around
3. Where Has My Little Dog Gone?
4. Skip to My Lou
5. Polly Put the Kettle on
6. Humpty, Dumpty
7. For He’s a Jolly Good Fellow
8. On Top of Old Smokey
9. Aiken Drum
10. Diddle, Diddle, Dumpling
11. One, Two, Buckle My Shoe
12. Toyland
SONG LYRICS
Song 1
I’m a puppy, and I like to play.
I walk and run and sleep all day.
Woof, woof, woof, woof, woof.
Woof, woof, woof, woof, woof.
Woof, woof, woof, woof, woof.
I’m ready to go for a walk with you!
Song 2
A B C D E F G,
H I J K L M N O P.
Q R S T U V,
W X Y and Z.
Now I know my ABCs,
Next time won’t you sing with me! 9
9
9

Song 3
I love to play with you every day.
We can play fetch or go for a walk.
When we get tired, we can take a nap.
Wherever you go, I wanna be with you.
Song 4
D is for dog.
Duh-duh-duh-dog.
D is for dog. I’m your dog!
Song 5
When we play, I wag my tail,
Wag, wag, wag, wag my tail.
When we play, I wag my tail,
I feel so happy!
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
10
10
10