Valcourt FP10 Lafayette User manual

FP10 LAFAYETTE IIS — ZC WOOD FIREPLACE QUICK INSTALL/REFERENCE GUIDE
Listed to UL 127 and ULC-S610 Standards
Page 1
(08-2020)
THIS QUICK REFERENCE PRODUCT SHEET IS NOT COMPLETE AND IS SUBJECT TO CHANGE WITHOUT NOTICE.
ALWAYS REFER TO OWNER'S MANUAL ACCOMPANYING THE PRODUCT TO AVOID RISK OF FIRE AND INJURIES.
ADDITIONAL INFORMATION CAN BE FOUND IN THE OWNER'S MANUAL ONLINE AT WWW.VALCOURTINC.COM.
APPLIANCE DIMENSIONS FRAMING DIMENSIONS
CORNER INSTALLATION
50 1/4"
1275 mm
70 3/8"
1788 mm
14 3/8"
365 mm
50 1/4"
1275 mm
14 3/8"
365 mm
LEGEND
Combustible
material allowed
in this area
Non-combustible
material only
in this area
A
F
28 5/8 "
727 mm
14 3/4 "
376 mm
23 7/8 "
607 mm
4 7/8 "
125 mm
40 5/8
"
1032 mm
2 1/2 "
64 mm
37 1/4
"
945 mm
16 5/8
"
422 mm
O
13 3/8
"
341 mm
8 1/8 "
206 mm
18 3/8 "
467 mm
28 5/8 "
727 mm
36 3/4 "
933 mm
6 "
152 mm
GG
9 1/8
"
231 mm
23 13/16 "
606 mm
10 7/16 "
266 mm
F
14 3/4 "
376 mm
16 5/8
"
422 mm
Electrical inlet
COMBUSTIBLE
VARIABLE
37 3/4"*
24 7/8"
631 mm
953 mm
MIN.
NON-
COMBUSTIBLE
COMBUSTIBLE
COMBUSTIBLE
40 5/8"
1032 mm
VARIABLE**
This space must
remain empty.
80"
2032 mm
NON-
COMBUSTIBLE
* Where applicable, add 12’’ for fresh air pipe
and/or 18’’ for forced air pipe to the width
of the chase. When drywall panels or any
other finishing material inside the chase around
the fireplace is to be used, add its thickness
to the measurement.
** For height equal or less than 4’’, see hearth
extension section on reverse.

FP10 LAFAYETTE IIS — ZC WOOD FIREPLACE QUICK INSTALL/REFERENCE GUIDE
Listed to UL 127 and ULC-S610 Standards
Page 2
(08-2020)
THIS QUICK REFERENCE PRODUCT SHEET IS NOT COMPLETE AND IS SUBJECT TO CHANGE WITHOUT NOTICE.
ALWAYS REFER TO OWNER'S MANUAL ACCOMPANYING THE PRODUCT TO AVOID RISK OF FIRE AND INJURIES.
ADDITIONAL INFORMATION CAN BE FOUND IN THE OWNER'S MANUAL ONLINE AT WWW.VALCOURTINC.COM.
HEARTH EXTENSION CONSTRUCTION AND DIMENSIONS
LEGEND
FACING MATERIAL SHELF, MANTLE, AND WALL PROJECTION
80"
2032 mm
1 1/2"
38 mm
1 1/2"
38 mm
Non-combustible facing material must extend to the ceiling
and have minimum height of 80
" (2032 mm).
OPTION #1 OPTION #2
OPTION #3
Non-combustible
floor protection
Non-combustible
material only
in this area
Non-combustible
floor covering
Combustible
material allowed
in these areas
Floor covering
Floor protection
Where R-value is required,
refer to manual for
equivalent insulation.
Where R-value is required,
refer to manual for
equivalent insulation.
Directly on the floor:
R-value required: 1.00 or greater
Raise base of 4" or less:
R-value required: 1.00 or greater
Raise base of more than 4":
No R-value required
B
B
45°
C
C
80"
2032 mm
48"
1219 mm
80"
2032 mm
* Clearance may be
reduced by use of
approved heat shield.
See Owner’s manual.
No combustible
material in this area
3"
76 mm
8"
203 mm
13"
330 mm
45°
POSITIONING AND DEPTH OF THE THE SHELF
B58" (1,47 m) 60" (1,52 m) 62" (1,58 m) 64" (1,63 m)
C6" (152 mm) 8" (203 mm) 10" (254 mm) 12" (305 mm)
≤ 4"
101,6 mm
16"
406 mm
2"
51 mm
2"
51 mm
8"
203 mm
41 1/2"
1054 mm
16"
406 mm
8"
203 mm
2"
51 mm
2"
51 mm
41 1/2"
1054 mm
> 4"
101,6 mm
16"
406 mm
2"
51 mm
2"
51 mm
2"
51 mm
2"
51 mm
41 1/2"
1054 mm
8"
203 mm