Varytec Battery Event Par IP65 6in1 User manual

Battery Event Par IP65 6in1
LED Spotlight
User Manual

Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: [phone]
Internet: www.thomann.de
12.09.2023, ID: 435529 (V4)

Table of contents
1 General information................................................................................................................................. 6
1.1 Symbols and signal words............................................................................................................... 6
2 Safety instructions..................................................................................................................................... 9
3 Features....................................................................................................................................................... 13
4 Installation.................................................................................................................................................. 15
5 Starting up.................................................................................................................................................. 21
6 Connections and controls................................................................................................................... 23
7 Operating.................................................................................................................................................... 26
7.1 Starting the device........................................................................................................................... 26
7.2 Main menu.......................................................................................................................................... 26
7.3 Enabling and disabling of the wireless DMX connection.................................................. 29
7.4 Functions in 3-channel DMX mode........................................................................................... 30
7.5 Functions in 4-channel DMX mode........................................................................................... 30
7.6 Functions in 6-channel DMX mode........................................................................................... 31
7.7 Functions in 9-channel DMX mode........................................................................................... 31
7.8 Functions in 11-channel DMX mode........................................................................................ 33
7.9 Menu overview................................................................................................................................. 34
8 Technical specications....................................................................................................................... 35
Table of contents
Battery Event Par IP65 6in1 3
LED Spotlight

9 Plug and connection assignments.................................................................................................. 37
10 Troubleshooting...................................................................................................................................... 38
11 Cleaning....................................................................................................................................................... 40
12 Protecting the environment.............................................................................................................. 41
Table of contents
4Battery Event Par IP65 6in1
LED Spotlight

Battery Event Par IP65 6in1 5
LED Spotlight

1 General information
This document contains important instructions for the safe operation of the product. Read and
follow the safety instructions and all other instructions. Keep the document for future refer‐
ence. Make sure that it is available to all those using the product. If you sell the product to
another user, be sure that they also receive this document.
Our products and documentation are subject to a process of continuous development. They
are therefore subject to change. Please refer to the latest version of the documentation, which
is ready for download under www.thomann.de.
1.1 Symbols and signal words
In this section you will nd an overview of the meaning of symbols and signal words that are
used in this document.
General information
6Battery Event Par IP65 6in1
LED Spotlight

Signal word Meaning
DANGER! This combination of symbol and signal word indicates an
immediate dangerous situation that will result in death or
serious injury if it is not avoided.
WARNING! This combination of symbol and signal word indicates a pos‐
sible dangerous situation that can result in death or serious
injury if it is not avoided.
NOTICE! This combination of symbol and signal word indicates a pos‐
sible dangerous situation that can result in material and
environmental damage if it is not avoided.
Warning signs Type of danger
Warning – dangers due to batteries.
Warning – high-voltage.
Warning – dangerous optical radiation.
General information
Battery Event Par IP65 6in1 7
LED Spotlight

Warning signs Type of danger
Warning – suspended load.
Warning – danger zone.
General information
8Battery Event Par IP65 6in1
LED Spotlight

2 Safety instructions
This device is intended for use as an electronic lighting eect by means of LED technology. The
device is designed for professional use only and is not suitable for use in households. Use the
device only as described in this user manual. Any other use or use under other operating con‐
ditions is considered to be improper and may result in personal injury or property damage. No
liability will be assumed for damages resulting from improper use.
This device may be used only by persons with sucient physical, sensorial, and intellectual
abilities and having corresponding knowledge and experience. Other persons may use this
device only if they are supervised or instructed by a person who is responsible for their safety.
Extend the operating life of the device by regular breaks and by avoiding frequent
switching on and o. The device is not suitable for continuous operation.
Safety
DANGER!
Risk of injury and choking hazard for children!
Children can suocate on packaging material and small parts. Children can injure themselves when handling the device. Never allow
children to play with the packaging material and the device. Always store packaging material out of the reach of babies and small
children. Always dispose of packaging material properly when it is not in use. Never allow children to use the device without supervi‐
sion. Keep small parts away from children and make sure that the device does not shed any small parts (such knobs) that children
could play with.
Intended use
Safety instructions
Battery Event Par IP65 6in1 9
LED Spotlight

DANGER!
Danger to life due to electric current!
A short circuit could lead to a re hazard and risk of death. Do not modify the mains cable or the plug! In case of isolation damage,
disconnect immediately the power supply and arrange repair. If in doubt, seek advice from a qualied electrician.
DANGER!
Danger to life due to electric current!
Within the device there are areas where high voltages may be present. Never remove any covers. There are no user-serviceable parts
inside. Do not use the device when covers, safety equipment or optical components are missing or damaged.
WARNING!
Risk of eye damage caused by high light intensity!
The device generates highly intense light radiation. Looking directly into the light source can damage the eyes. Never look directly
into the light source.
WARNING!
Risk of epileptic t due to ashing lights!
The device emits ashing lights (strobe eects). Flashing lights can trigger epileptic ts in specic people. If you are at risk of epi‐
lepsy, avoid spending longer periods of time subjected to ashing lights and looking into strobing light.
WARNING!
Incorrect handling of lithium batteries can result in injury!
In the event of a short circuit, overheating or mechanical damage, lithium batteries can cause severe injuries. Handle lithium bat‐
teries in a correct and professional manner. Store lithium batteries in a cool and dry place in their original packaging. Keep lithium
batteries away from sources of heat. Never open lithium batteries. Only charge rechargeable lithium batteries with a suitable
charger. Remove the lithium batteries before disposing of the device. Cover the poles of used lithium batteries with adhesive tape to
prevent short circuits. Electrolyte can escape from damaged lithium batteries. Put the damaged lithium battery in air-tight pack‐
aging. Collect the electrolyte with absorbent paper. Wear rubber gloves while doing so.
Safety instructions
10 Battery Event Par IP65 6in1
LED Spotlight

NOTICE!
Risk of re due to covered vents and neighbouring heat sources!
If the vents of the device are covered or the device is operated in the immediate vicinity of other heat sources, the device can over‐
heat and burst into ames. Never cover the device or the vents. Do not install the device in the immediate vicinity of other heat
sources. Never operate the device in the immediate vicinity of naked ames.
NOTICE!
Damage to the device due to high voltages!
The device can be damaged if it is operated with the incorrect voltage or if high voltage peaks occur. In the worst case, excess vol‐
tages can also cause a risk of injury and res. Make sure that the voltage specication on the device matches the local power grid
before plugging in the device. Only operate the device from professionally installed mains sockets that are protected by a residual
current circuit breaker (FI). As a precaution, disconnect the device from the power grid when storms are approaching or it the device
will not be used for a longer period.
NOTICE!
Risk of re by exceeding the maximum current
The device can supply power to other devices of identical design and connected in series. If too many devices are connected, the
power consumption can exceed the maximum permitted power consumption, which can cause the device to overheat and burst
into ames. Only connect devices of identical design to the device. When deciding how many devices you can connect in series,
make sure that the maximum permitted power consumption as stated on the device is not exceeded. Also refer to the specications
in the technical specications for the device. Only use power cords with a cable cross-section designed for the required current
intensity when connecting the devices in series.
NOTICE!
Possible damage to lithium-ion batteries through incorrect storage!
Deep discharge can permanently damage lithium-ion batteries or cause them to lose some of their capacity. Charge the lithium-ion
batteries before longer breaks in use and before storage. Ensure that the device is switched o for storage. Store the device at room
temperature or cooler in an environment as dry as possible. Recharge the lithium-ion batteries about every three months if they are
stored for a longer period of time to avoid permanent damage due to too deep self-discharge. Fully charge the lithium-ion batteries
only shortly before use at room temperature.
Safety instructions
Battery Event Par IP65 6in1 11
LED Spotlight

NOTICE!
Possible damage due to leaking batteries!
Batteries can leak and cause permanent damage to the device. Take the batteries out of the device if it is not going to be used for an
extended period of time.
NOTICE!
Risk of re due to incorrect polarity!
Incorrectly inserted batteries may cause res and destroy the device and the batteries. Observe the markings on the batteries and on
the device. Ensure that proper polarity is observed when inserting batteries.
Safety instructions
12 Battery Event Par IP65 6in1
LED Spotlight

3 Features
Due to its sturdy and weather-proof housing made of die-cast aluminium, the battery-pow‐
ered LED spotlight is especially suitable for outdoor use. With the very bright six-colour LEDs, it
is particularly suitable for professional lighting tasks.
Special features of the device:
n6 × six-colour LEDs (RGBWAUV, each 15 W)
nControl via DMX, W-DMX, the supplied IR remote control and via buttons and display on
the unit
nBuilt-in automatic show programmes
nMaster / Slave operation
nSound control
nInternational Protection Rating IP65
nSturdy double bracket for secure attachment to trusses or rm footing on the ground
nConnectors for power supply and DMX control via splash-proof lockable plugs and cou‐
plings
nMains power adapter with safety plug included
nRugged die-cast aluminium housing
nPressure compensation element (prevents condensation inside the device)
nBuilt-in receiver module for wireless control, compatible with Wireless Solution 5G
nW-DMX transmitter optionally available (item number 573998)
Features
Battery Event Par IP65 6in1 13
LED Spotlight

Equipment with protection class IP65 are dust-tight and completely protected against contact
(rst code number). They are also protected against splash water from any angle (second code
digit). That is why this equipment can also be used outdoors. Event technology equipment is
generally only designed for temporary use however (event lighting) and not for permanent
use outdoors.
The specied protection class does not make a statement about the weather resistance of the
equipment (resistance to changing ambient conditions as well as against the eects of sun‐
light and UV rays).
The seals and screw connections of the equipment must be checked regularly to ensure a
fault-free operation. In cases of doubt, consult a specialist workshop in due time.
For technological reasons, the light output of LEDs decreases over their lifetime. This eect
increases with higher operating temperature. You can extend the service life of the illuminants
by providing adequate ventilation and operating the LEDs with the lowest possible brightness.
Information about protection
class IP65
Features
14 Battery Event Par IP65 6in1
LED Spotlight

4 Installation
Unpack and check carefully there is no transportation damage before using the unit. Keep the
equipment packaging. To fully protect the product against vibration, dust and moisture during
transportation or storage use the original packaging or your own packaging material suitable
for transport or storage, respectively.
WARNING!
Risk of injury from falling devices that were inadequately secured!
If devices are not properly secured during assembly, they can cause severe injury
and considerable damage by falling.
When installing and operating, make sure to follow the standards and regulations
that apply in your country.
Always secure the device with a secondary safety attachment, such as a safety
cable or a safety chain.
Installation
Battery Event Par IP65 6in1 15
LED Spotlight

NOTICE!
Risk of overheating due to bad ventilation!
If the device is badly ventilated, the device can overheat.
Do not operate the unit at ambient temperatures outside the specied tempera‐
ture range (see chapter "Technical data" of the user manual).
Always ensure sucient ventilation at the operating location.
NOTICE!
Potential property damage due to unsuitable stands!
If the device is mounted on an unsuitable stand, there is a risk that the stand will
fall over and cause damage.
Only use stands whose maximum bearing capacity is at least as high as the
weight of the device. Always ensure that the stand is stable.
Installation
16 Battery Event Par IP65 6in1
LED Spotlight

NOTICE!
Data transfer errors due to improper wiring!
If the DMX connections are wired incorrectly, this can cause errors during the data
transfer.
Do not connect the DMX input and output to audio devices, e.g. mixers or ampli‐
ers.
Use special DMX cables for the wiring instead of normal microphone cables.
NOTICE!
Possible damage due to moisture penetrating into open connectors!
Moisture entering open connectors (plugs and couplings) of DMX and power
supply cables can cause short circuits and damage to connected xtures.
Always seal unused connectors with end caps intended for this purpose
(www.thomann.de).
nThis equipment uses a frequency range that is free of charge and registration within the
European Union.
For more information, please visit: http://www.thomann.de.
nMake sure that no metal objects are located between transmitter and receiver.
nAvoid interference by other radio and in-ear systems.
Notes on radio transmission
Installation
Battery Event Par IP65 6in1 17
LED Spotlight

You can install the unit in hanging or standing positions. When in use, the device must always
be attached to a solid surface or an approved mount. Use the openings provided on the two-
piece bracket for attaching.
Always work from a stable platform whenever installing, moving or servicing the device. While
you do this, the area underneath the device must be cordoned o.
The safety cable must be attached to the bracket.
Please note that this device must not be connected to a dimmer.
Mounting options
Installation
18 Battery Event Par IP65 6in1
LED Spotlight

Push the lock of the battery holder towards the centre of the housing and pull out the battery
holder like a drawer. Insert the batteries. The battery is correct if the positive pole points to the
housing base of the remote control. Slide the battery holder back into the remote until it clicks
into place.
When shipping, the battery is already installed in the remote and protected against discharge
by a transparent plastic lm. Remove the plastic lm before initial use.
NOTICE!
Risk of re due to incorrect polarity!
Incorrectly inserted batteries may cause res and destroy the device and the bat‐
teries.
Observe the markings on the batteries and on the device.
Ensure that proper polarity is observed when inserting batteries.
NOTICE!
Possible damage due to leaking batteries!
Batteries can leak and cause permanent damage to the device.
Take the batteries out of the device if it is not going to be used for an extended
period of time.
Inserting the battery into the
remote control
Installation
Battery Event Par IP65 6in1 19
LED Spotlight

NOTICE!
Possible damage due to leaking batteries!
Batteries can leak and cause permanent damage to the device.
Take the batteries out of the device if it is not going to be used for an extended
period of time.
NOTICE!
Risk of re due to incorrect polarity!
Incorrectly inserted batteries may cause res and destroy the device and the bat‐
teries.
Observe the markings on the batteries and on the device.
Ensure that proper polarity is observed when inserting batteries.
Installation
20 Battery Event Par IP65 6in1
LED Spotlight