Vecnum trigLOC User manual

Please pay attention to the 4° indexing:
The pin has to be insert always into
the opposed holes
Loos upper bolt
Tighten upper
bolt
Adjust tilting
and tighten the clamp
Attention:
Small loose part
Take off SRAM
trigger mount interface
carefully
Dene trigger orientation
by inserting the pin into the
corresponding position
Communication
Phone
Germany
Install trigLOC select axial direction
trigLOC mounting
trigLOC adjust trigger rotation
Allen key 5mm
Allen key 5mm
Allen key 5mm
Installation manual

Tighten clamping screw
Insert cable
Cable clamp at lever
side. (moveLOC)Cable clamp at dropper
post side
Cable installation
Remove cable and
existing cable
return spring
Install new cable return
spring and cable into
cable housing
Pay attention to the
steering angle
Remove remote cable
from dropper post
Loosen cable clamp at universal
remote and remove lever
Loosen cable clamp
Replace cable return spring (moveLOC dropper post only)
Allen key 2.5mm
Allen key 1.5mm
Allen key 1.5mm
Possible Installation
options
Advice:
Cut the cable
at nipple side
to the desired
length in that
way, that the
soldered end of
the cable r exactly
into the trigger paddle.