Vela Latin 100 User manual

VELA Latin
100/200/300
VELA Latin 200VELA Latin 100
VELA Latin 300
USER MANUAL EN
VARIANT:
Manual no. 105378

TABLE OF CONTENTS
1.0. INTRODUCTION 3
1.1. WARNINGS 4
1.2. TROUBLESHOOTING 5
1.3. LABELS USED ON THE CHAIR 6
1.4. SAFETY 7
1.4.1. Application 7
1.4.2. Transport 7
1.5. WARRANTY 7
1.6. UNPACKING THE CHAIR 7
1.7. MAINTENANCE 8
1.7.1. Wheels 8
1.7.2. Frame 8
1.7.3. Padding 8
1.7.4. Recycling guide 8
1.8. RECYCLING AND DISPOSAL 8
1.9. USER MANUAL 9
1.9.1. Attaching the backrest 9
1.9.2. Adjustment of seat height with foot ring 9
1.9.3. Adjustment of seat height with lever 9
1.9.4. Adjustment of seat tilt 9
1.9.5. Adjustment of back height 10
1.9.6. Adjustment of back tilt 10
1.9.7. Back latch (VELA Latin 200) 10
1.9.8. armrest (optional) 10
1.9.9. Footrest ring (optional) 11

3
1.0. INTRODUCTION
DEAR CUSTOMER
Congratulations on your new VELA chair! We are sure
this chair will give you daily pleasure. This user manual
provides useful information on adjusting, operating
and maintaining your chair.
Important
Please read this user manual carefully and keep it safe
for when you need to refer to it. This manual is also
available on VELA’s website: www.vela.eu, where you
can also find other relevant information.
If you have any questions, please contact your
supplier.
We reserve the right to make changes.
VELA
Gøteborgvej 8-12
9200 Aalborg SV
Denmark
www.vela eu

4
1.1. WARNINGS
Use In case of an allergic reaction, stop using the chair and consult a doctor
Use Only use original spare parts from VELA
Use Do not make any changes to the accessories that come with the chair
Use Only use the chair for the intended purpose
Use Only adjust the seat angle while the user’s feet are on the floor
Use Never use the chair on surfaces with level dierences as the chair may become unstable
Use Maintenance other than cleaning should always be performed by a professional
Use Never service the chair while it is in use
Use Always follow the recommended maintenance and cleaning instructions
Use The chair's functions are intended for the user. Only the user or trained professionals
should adjust the chair while the user is sitting in it
Use Risk of shearing or squeezing fingers in moving parts. Therefore, never use the chair if
someone is touching underneath the seat
Choking hazard Choking hazard on small parts. Never allow children to play with the chair, as small parts
are removable

5
1.2. TROUBLESHOOTING
Mistake Possible cause and solution
Manual height adjustment does not work There is too much load or uneven load on the chair.
Try to adjust the height without sitting in the chair. If
this does not work, the gas cartridge is defective and
should be replaced. Contact your VELA supplier
The chair rolls badly Wheels are blocked. Clean the wheels for wire residue
and the like.
If the above does not solve your problem, you should contact your VELA
supplier.

6
IN GENERAL
1.3. LABELS USED ON THE CHAIR
Warning Risk of shear and squeeze:
Keep hands and fingers away from moving parts
Icon
Read ”Instruction For Use” before use
Icon
Part used:
Type B cf. IEC60601-1
covering the following areas of the chair:
Labels
60 x 22.5 mm
Labels on the chair should be read at a distance of approx. 40 cm under nor-
mal daylight conditions.
For labels related to the operation of the chair, please refer to section 1.9.
IdentNo.:
<Model name>
<Model ref no.>
<Manufacturer>
<Adress>
<Webpage>
<IdentNo.>
<Safe Working load>
<Production date/order no.>
<ME Equipment mass>

7
1.4. SAFETY
This chair is CE marked and com-
plies with applicable EU regulations.
The chair is manufactured by:
VELA, Gøteborgvej 8-12,
9200 Aalborg SV, Denmark.
1.4.1. APPLICATION
This chair is an indoor chair inten-
ded for sitting and private use.
:: The chair is not built to stand on
All variants of this chair are tested
and approved for a maximum load
of 125 kg.
1.4.2. TRANSPORT
When transporting the chair by
car, airplane or any other means
of transport, always use the chair
brake. The chair is not approved
for use as a passenger seat in any
means of transportation and may
not be used as such.
The chair is designed to be
transported under the following
environmental conditions:
Temperature: - 20°C to + 60°C
Humidity: 15-95%
Allow the chair to stand for 24 hours
before use if it has been stored
below - 10°C.
1.5. WARRANTY
VELA grants a right of claim under
applicable law in the country where
the chair is acquired. The right of
complaint applies only when using
original spare parts and accessories,
as well as customisations made by
professionals.
Note: if an exclusive contractual
agreement has been made directly
with VELA, this applies!
VELA assumes no liability for da-
mages to the product or the user
caused by:
:: Transportation
:: Misuse
:: Normal wear and tear
:: Wrong use
:: Use of spare parts and acces-
sories that are not original VELA
products
:: Adjustments made by unauthori-
sed service technicians
1.6. UNPACKING THE CHAIR
The chair comes in environmentally
friendly and recyclable packaging.
In case of defects or transport
damage to the chair, please contact
your VELA supplier right away. In
such cases, do not attempt to use
the chair or to fix it yourself.

8
On delivery you have received:
:: VELA chair
:: Instructions for use
Note: see item 1.9.1 for correct
attachment of backrest.
1.7. MAINTENANCE
We recommend an annual inspec-
tion of the chair to identify any¬ de-
fective or worn parts. All removable
parts should be tightened regularly.
You can find various guides on
www.vela.eu.
1.7.1. WHEELS
We recommended you regularly¬
check the wheels and remove any
residual threads, etc.
1.7.2. FRAME
Clean with lukewarm water and if
necessary, add some pH-neutral
detergent.
1.7.3. PADDING
Fabric: Clean by chemical cleaning,
with furniture cleaner or with water
using a hard-wrung cloth.
Synthetic fabric or leather: Clean
with water or mild soap using a
hard-wrung cloth.
Leather: Clean by vacuuming with a
soft brush. Avoid using detergent.
Note: On www.vela.dk you can find
cleaning instructions for all our stan-
dard upholstery types.
1.7.4. RECYCLING GUIDE
Your VELA chair can be reused by
another person when you no longer
need it as long as the chair is servi-
ced by a technician beforehand.
The life expectancy of the chair is
five years for regular and proper use
as long as VELA, your VELA supplier
or a trained professional perform an
annual inspection with replacement
of worn parts.
1.8. RECYCLING AND DISPOSAL
This product contains recyclable ma-
terials. Therefore, the product must be
disposed of in accordance with local
regulations and not together with
ordinary household waste. Proper dis-
posal and recycling will help prevent
negative eects on the environment
and people.

1.
2.
9
1.9.3. ADJUSTMENT OF SEAT HEIGHT WITH LEVER
Adjust the seat height by pushing the lever placed at your
right hand.
1.9.4. ADJUSTMENT OF SEAT TILT
Adjust the seat tilt by pushing the middle lever placed at your
right hand.
1.9.2. ADJUSTMENT OF SEAT HEIGHT WITH FOOT RING
Adjust the seat height with your foot by pushing the ring, which
is placed at the base og the chair.
1.9. USER MANUAL
Replacement of the gas spring may only be performed
by the service support team from your dealer or a
skilled technical person.
1.9.1. ATTACHING THE BACKREST
The lever for backrest adjustment (1) must be in open position.
Press the locking pin spring (2) and push the backrest arm
through the hole. Tighten the lever afterwards.
Note: The backrest arm must be pushed through completely
so the pin spring locks the backrest arm. Make sure that the
backrest arm cannot be pulled out again.

VELA
LATIN
200
10
1.9.7. BACK LATCH (VELA LATIN 200)
The backrest can be set to a specific angle by adjusting and
secure the the bolt which is mounted on the rear side of the
backrest.
1.9.8. ARMREST (OPTIONAL)
K1 armrest with 5 click height adjustment can be adjusted to
point inward, outward and straight forward. K1 is easy to adjust
using the button on the underside of the armrest.
1.9.6. ADJUSTMENT OF BACK TILT
Adjust the back tilt by pushing the rear lever placed at your
right hand.
1.9.5. ADJUSTMENT OF BACK HEIGHT
Adjust the back height by using the lever placed on the back of
the chair. Remember to tighten the handle again afterwards.

11
1.9.9. FOOTREST RING (OPTIONAL)
A 45 cm footrest ring, adjustable in height. The footrest ring
provides stability, support and comfort in the sitting position. A
footrest ring is especially practical when the user is sitting high
up.

vela.eu
701.3923 © Vermund Larsen A/S
VELA :: Gøteborgvej 8-12 :: 9200 Aalborg SV :: Denmark :: [phone] :: [email protected]