Velux INTEGRA KLI311 Manual

English Setup of wall switch KLI 313 to operate VELUX INTEGRA®solar awning blind MSL 2
Deutsch Coming soon
Français Coming soon
Dansk Coming soon
Nederlands Coming soon
Italiano Coming soon
Español Coming soon
Bosanski Coming soon
Български Coming soon
Česky Coming soon
Eesti Coming soon
Hrvatski Coming soon
Latviski Coming soon
Lietuvių Coming soon
Magyar Coming soon
Norsk Coming soon
Polski Coming soon
Português Coming soon
Română Coming soon
Русский Coming soon
Slovenščina Coming soon
Slovensky Coming soon
Srpski Coming soon
Suomi Coming soon
Svenska Coming soon
Türkçe Coming soon
Українська Coming soon
VELUX INTEGRA®KLI 311/312/313

P
1 sec
1
2 3
4
6
max 3 sec
5
VELUX®2
ENGLISH
Setup of wall switch KLI 313 to operate
VELUX INTEGRA®solar awning blind MSL
If a non-functional wall switch must be replaced or if the wall switch cannot find certain products, the products can be
prepared for registration by resetting them manually.
Note: Reset products cannot be operated until they have been registered in the wall switch again.
Important: This only applies to KLI 313.
1Remove plastic cover.
6Replace plastic cover.
The awning blind can now be operated with the wall switch.
Note: The motor must be adjusted to the size of the window before full operation
of the awning blind begins. The adjustment will take place automatically the first
time the awning blind is operated. Before the awning blind runs to the preferred
position, it runs all the way up and down. Do not interrupt the adjustment!
2Set switch to position I.
3Press button P briefly.
Note: Registration ( 4and 5) must
now be completed within the next
10 minutes.
4Press PAIR button on the wall
switch for 1 second.
5Press the STOP key and then the
DOWN key within 3 seconds.