Velux KLI 311 Specification sheet

English Setup of wall switch KLI 312 to operate VELUX INTEGRA®solar powered blinds DSL/RSL/FSL/FSC 2
Deutsch Coming soon
Français Coming soon
Dansk Coming soon
Nederlands Coming soon
Italiano Coming soon
Español Coming soon
Bosanski Coming soon
Български Coming soon
Česky Coming soon
Eesti Coming soon
Hrvatski Coming soon
Latviski Coming soon
Lietuvių Coming soon
Magyar Coming soon
Norsk Coming soon
Polski Coming soon
Português Coming soon
Română Coming soon
Русский Coming soon
Slovenščina Coming soon
Slovensky Coming soon
Srpski Coming soon
Suomi Coming soon
Svenska Coming soon
Türkçe Coming soon
Українська Coming soon
VELUX INTEGRA®KLI 311/312/313

max 3 sec
1 sec
2
3
4
VELUX®2
ENGLISH
1Depending on the blind, the RESET
button will be located as shown in
illustration 1A or 1B .
Press the RESET button on the
blind for 10 seconds (motor makes
a brief buzzing noise, but the prod-
uct does not move).
Note: Registration ( 2and 3) must
now be completed within the next
10 minutes.
4The blind can now be operated with the wall switch.
NOTE: The motor must be adjusted to the size of the window before full
operation of the solar sunscreening product begins. This is done by running
the solar sunscreening product all the way up and down without interruption
using the wall switch.
If a non-functional wall switch must be replaced or if the wall switch cannot find certain products, the products can be
prepared for registration by resetting them manually.
Note: Reset products cannot be operated until they have been registered in the wall switch again.
Important: This only applies to KLI 312.
Setup of wall switch KLI 312 to operate
VELUX INTEGRA®solar powered blinds DSL/RSL/FSL/FSC
10 sec
10 sec
1A 1B
2Press PAIR button on the wall
switch for 1 second.
3Press the STOP key and then the
DOWN key within 3 seconds.