VendNet BC500 User manual

BILL CHANGER
Installation Guide
Model: BC500
BILL CHANGER ASSEMBLY
1._Specifications:
(1) Dimension: (H) 24¾ (W) 7 2/16 (D) 11½
Shipping Dimensions: (H) 30”(W) 13”(D) 17”
(2) Weight: Empty 39 lbs. Shipping Weight: 42 lbs.
(3) Power Requirement: AC 115v 60Hz
(4) Operating Temperature: 48˚F to 120˚F
(5) Operating Humidity: 30% to 85% RH
(6) Installation Location: Indoor
(7) Coin Capacity: Approx. 500 coins
(8) Counting Method: Two Optical Sensor
2. Panel:
3. Subassembly:

4. Fill Coin Box To A Level Higher Than The Sensors:

Procedure:
When ordering parts, include the following:
(1) The model and serial numbers of the machine for which the parts are needed.
(2) Shipping address
(3) Address where the invoice should be sent
(4) The number of parts required
(5) Always refer to the pertinent parts and/or part manual for the correct part
number and description of a specific part
Note: When RIGHT or LEFT is used with the name of a part, it means the person is
facing the machine with the door closed.
5. Bill Acceptor LED Display:
The two LED light located at the front of the unit will show the operational status of
the bill validator. The LED lights will flash ON and OFF (in 500ms intervals) when
the unit is ready to accept bills. The LED lights will be OFF if the unit is disabled or
out of service, in which case the unit will not accept any bills.
The bill validator can only accept one bill at a time. The LED lights will be OFF and
will not accept another bill while a bill is being validated in the unit. The LED lights
will start to flash normally when the bill validator is ready to accept the next bill.
6. LED Status:

7. Specifications:
(1)
Weight: Approx. 26oz.
(2) Power: DC+12V
(3) Environment Range
Operating temperature: 32˚F to 104˚F
Storage temperature: -8˚F to 116˚F
(4) Function 1:
Press and hold the reset key for 3 seconds to reset the counter back to “0”.
Function 2:
If more than 4 digits are stored on the counter, press the reset key to
display the next digits.
8. Trouble Shooting Table:

Procedure:
When ordering parts, include the following:
(1) The model and serial numbers of the machine for which the parts are needed.
(2) Shipping address
(3) Address where the invoice should be sent
(4) The number of parts required
(5) Always refer to the pertinent parts and/or part manual for the correct part
number and description of a specific part
Note: When RIGHT or LEFT is used with the name of a part, it means the person is
facing the machine with the door closed.
(6)
Any special shipping instructions
(7) Carrier desired: air or air special, truck, parcel post or rail
(8) Signature and date
(9) Purchase order number, if used
Mail your order to:
VendNet™
P.O. Box 488

165 North 10th Street
Waukee, IA 50263-0488 USA
All orders are carefully packed and inspected prior to shipment. Damage incurred
during shipment should be reported at once and a claim filed with the terminating
carrier. If you do not have The right parts manual: contact VendNet™. If you have
any questions, call:
Service: 1-888-VENDNET (836-3638)
Parts: 888-259-9965
Fax: [phone]
Email: [e-mail]
Web: www.vendnetusa.com