Veris Industries AG01E User manual

Installation Guide
Accessories
Z207061-0A Page 1 of 2 ©2015 Veris Industries USA 800.354.8556 or +1.503.598.4564 / suppor[email protected] 0415
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
TM
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classied locations.
•
Read and understand the instructions before installing this product.
• Turn o all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
No responsibility is assumed byVeris Industries for any consequences arising out of the
use of this material.
Product Overview
The AG01E carbon monoxide (CO) sensing element is designed to work with the Veris GWN Series gas platform unit
to provide monitoring of CO levels. Common sources of CO include automobile exhaust from gasoline engines,
gasoline powered furnaces, gasoline powered water heaters, and gasoline generators. The sensor is calibrated at
the factory, so no field calibration is needed. The AG01E is warranted to meet accuracy specifications for one year
after the date of manufacture.
AG01E
Carbon Monoxide Sensing Element
Specifications
Sensor Type Electrochemical
Measurement Range 0-500 ppm
Accuracy ±5% of range
Analog Output Scaling 0-200 ppm
Resolution 1 ppm
Sensor Warranty 1 year from manufacture date
Low Level Setpoint 25 or 35 ppm (switch selectable)
High Level Setpoint 180 ppm (fixed)
Operating Temperature Range -20° to 50°C (-4° to 122°F)
Operating Humidity Range 0-90% RH non-condensing
The AGxx sensors work only with Veris GWN Series gas platform devices.

Z207061-0A Page 2 of 2 ©2015 Veris Industries USA 800.354.8556 or +1.503.598.4564 / suppor[email protected] 0415
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
AG01E Installation Guide TM
Installation Observe precautions for handling static sensitive
devices to avoid damage to the circuitry that
is not covered under the factory warranty.
1. Disconnect and lock out all power sources before beginning the installation of the sensor.
2. Install the GWN Series gas platform according to the instructions included with that device.
3. Remove the front cover from the GWN Series gas platform device.
4. Use the grooves on the sides of the AG01E to correctly position the sensor with respect to the GWN unit.
5. Press the connector block on the sensor onto the connector pins on the GWN unit.
Use these grooves to position the sensor
properly before pressing the sensor into the
pin connector on the GWN board.
6. The low relay setpoint value of the AG01E sensor is selectable (either 25 or 35 ppm). Use the setpoint selection switch on the
GWN board to choose LO (for 25 ppm) or HI (for 35 ppm).
The AG01E high setpoint value is fixed.
7. Replace the GWN front cover. Reconnect power.